KUDA22SWWH0 KitchenAid Dishwasher - Instructions

Simply inserted the new rubber hose on the two fittings - a couple of minutes at most

I pulled out the old hose and pushed in the new one. Took a little muscle, but was glad that it fit. On line site very helpful with description so that it fit perfectly!

Simply popped on new axles and wheels and dishwasher works like new!

I had repaired the hose with duck tape several times, and finally was able to convince my husband to look up the model number etc. went on line to see if I could locate a dealer to get the hose, and that was so easy,
Ordered it, it came in 2 days, and my dishwasher works great again.

It was so easy just took off the old hose and snapped in the new one.

For several years I endured difficulty in pushing in and pulling out a fully loaded lower dishwasher tray in my KitchenAid Superba dishwasher. The tray would "fall out" out of its "track" and jam requiring me to lift up the whole tray to try to pull it out. Then one of the plastic roller "axles" broke and its wheel fell off. So I went on to Part Select's website to find a replacement. When I got it in the mail I replaced the one that broke. I noticed how much more rigid the wheel then ran on its "track." So I replaced all the roller axles and, lo and behold, the lower tray does not jam anymore. It rolls just like new! I am very satisfied. Chris from Bay Ridge, Brooklyn

Took the tube off and noted that there was a factory drilled hole on the underside that lets water drain. I slipped the new tube over the inlet port and the other end over the rotating washing arm aparatus port and everything worked fine. Very easy and fast repair.

One of the axles broke off, requiring no removal. The other wheel broke off, but the axle remained. That required squeezing (pliers) to push out. Replacement was easy; just put wheel onto axle and push axle through mounting space. Total: 5 minute job.

Very easily!! I am 19 years old and repaired the dishwasher for my grandmother in about 15 minutes. Great products.

I placed the hose on one side after placing one end in boiling water. I placed the other end in the hot water and pushed it on.

Removed the old tube with the aid of a knife to cut one end off the fitting. Then I lubed each end of the tube with dish washing soap and slipped them on. Done in 10 minutes. Easier to do if the top rack is removed for better access to the hose connections.

All I had to do was remove the damaged hose and replace it with the new hose. It took all of 5 minutes. The dishwasher is working like new!

took old tube of and heaten new tube to soften it. put some plumber grease on ends and slipped it on. longest time was boiling the water.

I simply removed the broken wheel brackets and snapped new ones on. then the wheel just sliped on. It took some good hand strength.

While replacing the water valve I broke the float switch. Ordered the switch....it was here in 2 days. Great service! Will use this company again....I hope not all that much. lol
I am a retired Sears service tech, but not a dishwaher tech.
Love Parts Select!
Thanks guys,
Doug

Removed the door cover and replaced the bi-metal.