All Installation Instructions for KitchenAid Microwave KHMC1857BSP0

Microwave had no electrical

I was sent the wrong fuse by you. I had to procure a fuse in another manner. Very disappointing. The repair was simple. It just took longer because of the failure to send the correct fuse.

Parts Used:

R Ceramic Fuse 20 A

Larry from HARKER HTS, TX
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Burnt Out Light Bulb Replacement

Open compartment, installed bulb, closed compartment

Parts Used:

Light Bulb - 40W

alfred from summerville, SC
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

9 of 30 people found this instruction helpful.

Was this instruction helpful to you?

it was working fine and it stopped order a fuse and it wasn't the problem

took it to Buttermore appliance in Auburn Indiana and he changed the fan and added another fuse

Parts Used:

R Ceramic Fuse 20 A

Herb from Auburn, IN
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours

0 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Put the Fuse in, then plugged it in came on for a min then everything went out!!!!!

Took the front off and behind a plate was the fuse, so I replaced it for what good that did!!!

Parts Used:

R Ceramic Fuse 20 A

Stephen from SPRINGFIELD, WV
Difficulty Level:
Very Difficult
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers

4 of 18 people found this instruction helpful.

Was this instruction helpful to you?

replace filter

Time to replace the charcoal filter

Parts Used:

Charcoal Filter

Robert from Southfield, MI
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

replacing filter

To replace charcoal filter in microwave, had to take grill off. Tabs on 2 of the 3 screws were fractured and then glued. This happened at the factory. Found Parts Select on the internet who had the grill and filter. Received parts in less than 5 days. Grill was easy to install as the 3rd tab had been eliminated on the replacement part. THANKS PARTS SELECT

Parts Used:

Vent Grille - White

Charcoal Filter

Charles from Prineville, OR
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

2 burned out bulbs under the microwave/important light source for kitchen stove.

I didn't do the repair -- my husband did, said it was easy, had no problems what so ever! The new bulbs give a lot more light to the cooking area.

Parts Used:

Light Bulb - 40W

Ferol from San Antonio, TX
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Noisy turntable motor

Unplug microwave. Remove turntable and support from inside. Remove outside bottom cover (10 screws). Remove 2 torx screws holding motor in place. Remove 2 wires from motor, noting colors. Wires are held with spade connectors that has a small tab that needs to be depressed. Remove washer from motor and place on new motor. Entire procedure very easy.

Parts Used:

Turn Motor

Bruce from Rock Island, IL
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

replace filter

slide into place under hood

Parts Used:

Grease Filter

Barbara from Cranston, RI
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

burnt out light bulb

The problem I have with changing the bulb is my microwave is an overhead one and therefore I cannot tip it on its side to easily replace the bulb. I have to drop the lid down and carefully install the new bulb from underneath.

Parts Used:

Light Bulb - 40W

Shirley from Londonderry, NH
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Needed a clean filter

Stood on a step stool (microwave over stove), took off the one panel,removed old filter and put in new one

Parts Used:

Charcoal Filter

Ethel from New Berlin, WI
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

in 2 yrs the charcoal filter had NEVER been changed and it was smelling horrible--so had to be done !

--simpley removed 2 screws, removed old filter--but had PLENTY of cleaning to do before putting in the new filter !My husband LOVES to cook and pan fry foods--it won't go that long before being replaced in the future!

Parts Used:

Charcoal Filter

carole from North Canton, OH
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Filter dirty

I unscrewed the filter cover, replaced the charcoal filter and replace the cover. The other wire mesh filter slides right into place. You sent me the right parts for my filter replacement on my microwave. Easy install. Thanks

Parts Used:

Grease Filter

Charcoal Filter

John from Denver, CO
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Broken plate

Took the replacement plate out of the box and put it in the microwave in seconds. I never realized how much of a difference having the correct microwave plate would make. It's great to have it back.

Parts Used: