All Installation Instructions for KitchenAid Microwave Oven Combo KEMS308SSS02

Replace Broiler Element on a slide in range

Using the video from PartSelect I followed the steps shown. Sliding the range out was difficult so I tilted it forward resting the frame on a 5 gallon plastic bucket. I did have to crimp on a new terminal. The repair was straightforward.

Parts Used:

Element, Broil

Richard from EUGENE, OR
Difficulty Level:
A Bit Difficult
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Broken mounting bracket for coils in convection microwave.

Very easy, fit perfectly.No tools required.

Parts Used:

GRILL SUPPORT

Larry from Fernandina Beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 10 people found this instruction helpful.

Was this instruction helpful to you?

Grill support broke. Sounds like a common problem based on other’s comment.

Turn the grill support 90 degrees to the opening in ceiling of micro. Insert then turn back 90 degrees so the support is in-line with the slot. Hang the wire on the support. Hours of worry over what this was gonna cost me to get repaired, then a 45 second fix costing only 29 bucks.

Parts Used:

GRILL SUPPORT

Andrew from LAKEVILLE, MN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

Micro Wave Steamer

I spoke to Daily via the phone and I ordered a new steamer since my original steamer cracked over a period of time. No installation, no problems I just recently used it and works perfectly! Thank You!

Parts Used:

Microwave Steamer

James from MIAMI, FL
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

I broke the glass cooking tray when instaling my oven microwave combo

I put the tray in the microwave???? Pretty easy.

Parts Used:

Microwave Turntable Tray

Jeff from Baytown, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Part broken

We ordered element support 3 times and all three times it came broken. The part is made of porcelain and is fragile , representative asked warehouse to pack it in the box and part still came in envelope.
Requested refund and ordered directly from factory.

Parts Used:

GRILL SUPPORT

Elena from HOUSTON, TX
Difficulty Level:
Very Difficult
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

The oven was over heating because it wasn’t reading the temperature

Pulled the stove out, unscrewed the back and plugged the new thermostat in. Screwed the back back on

Parts Used:

Range Temperature Sensor

LAURIE from BILTMORE LAKE, NC
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

wire came loose and shorted out

Ordering the part online was easy. It arrived in a timely manner. I found a terrific video online showing how to install the terminal. It was so easy. Thank you for the great instructional video.

Parts Used:

Range Main Power Terminal Block

Elizabeth from HOUSTON, TX
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

The light in our microwave was out.

We had to remove screws from the vent covers above and below the microwave, then there were 2 screws (one on each side) that attached the microwave to the oven. Once all of the screws were removed we had to pull the microwave out. Then we pulled the light cord out, removed the burnt out light and installed the new one. Then reversed the steps.

Parts Used:

Lamp Lens

Michael from Ladson, SC
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Oven light bulb inop

Taking off the glass lense for the light bulb was harder than I thought. It unscrews counterclockwise, but it was very hard to get off. It would not turn. I ended up using connector pliers I use for work, that has rubber jaws. The lense unscrewed very easy with it. Light also unscrews out. PartSelect.com is the only way to go to buy parts for appliances. It is simple, even has the illustrated parts catalog. And it saves a lot of time and gas, driving around looking for the part!!. PartSelect came through again.

Parts Used: