KBSD702MSS00 KitchenAid Refrigerator - Instructions

Watched the video it was right on, no problem.

1. I first confirmed that the problem was a bad Infrared Ice making control board (Watched flashing of red light on right side of freezer - solid light would not occur when holding flap on left side of freezer). 2. I unplugged refridg,3. unscrewed both sides of the control unit and disconnected wire clips to the electronic boards. 4.popped in new Boards on both sides and connected clips onto each board. 5. Screwed the boards and covers to walls of freezer. 6. Plugged power back into wall and checked Red light again (when holding flap in, a continuous red light verified it would work). closed freezer and shortly ice was being made. Simple process. (careful using Screwdriver to help take wire off of boards - a small clip holds wire clip on - you need to stick screwdriver into back of clip while unconnecting). Easy and my ice worked perfectly.

Remove 3 screws on the emitter and 3 screws on the receiver. Removed the plugs and reinstalled the parts. Very simple and easy. Ice is flowing again.

Replaces transmitter circuit board. Removed (3) screws and replaced board and replaced back into service. very easy!

Video made troubleshooting problem easy. I ordered the parts and 5 days later I had them. 10 minutes later they were installed and that night I had ice. This is the third appliance I have repaired using the partsselect video and replacement parts. All worked well. Much cheaper than getting a technician. Thank you. Cheap Guy!

Replaced the emitter and receiver boards by following the video instruction. Unscrew the cover plate, disconnect the wire, remove and replace the board and re-install. Repair was very easy and the unit is back in service.

took screwdriver, took out old parts. replaced with new parts. plugged fridge back in, turned on receiver. We have ice! Real Easy to install! Thank you Part Select.

Completely disconnected the power. Just shutting off the ice maker switch does not shut off the power to these boards. The emitter and Receiver boards are located in the side panels of the freezer-one on the right and the other on the left. Just remove the 3 screws in each cover and disconnect the wire connectors and install the new boards. It's very straight forward and easy to do.

i talked to a gentlman name Ruben and directed me to the parts i needed i ordered them and put them by myself i ended up saving over 200.00 dollars thanks to Select parts the minute i finished the process and closed the freezer doors i could hear the ice is comin down again it was good feeling. After i changed the emitter and the receiver this year every thing is working again

Replaced emitter and receiver boards. That did not fix the problem, ordered valve hope that is it.

The motor turned but the shaft had worn and was smooth rather than hexagon in cross-section. Part Select had the exploded view of the mechanism, which I could not find on Kitchenaid's site and I was able to order a replacement shaft, which I did and got within 3 days. I replaced the shaft without any difficulty and now I can enjoy my cocktails with ice from the in-door dispenser without sticking my hand in the ice bin. I am very pleased with Part Select, their website, their stock of parts and their efficiency.

The part arrived and we replaced both of the electronic control boards. Seemed fairly simple and immediately fixed the problem.

Unplug the Unit first! Unscrewed the sensor covers on both sides. Snap off the old, snap on the new. Replace the covers and screws.

watched the video how to remove, and did it.

Follow the video.