JVM1790WK01 General Electric Microwave - Instructions

Replace the fuses

Inside "cavity" bulb was a PITA. Need to remove top decorative trim (2 screws and tabs) to access bulb housing. Broke 1 screw tab so be careful (Wiggle it more). Acccess to bulb housing was made for younger smaller hands, attached by 1 screw. Remove screw, rotate housing, replace bulb. Reverse proceedure. Outside bulb, cake...1 screw, drop lens replace bulb, your done.

unscrew one screw and remove bulb and insert new bulb and replace lense with one screw-

as easy as it gets-

Repair was simple; only a phillips head screw driver was required to remove the access plate.

Part Select delivered the replacement lamps within 3 days from the date I placed the order - great service.

Unscrew (one screw) and take off the cover of the surface light under the microwave (the light over the stove). Firmly pull out the old light bulbs. Align the two prongs of the new bulbs into the socket and firmly push into the recepticle. Replace the cover and screw.

Just placed the rack in the Convection/Microwave oven and baked

No repair involved, just replaced......looked online and ordered, thought it would take 4-5 days, came in perfect condition within TWO 2 days. awesomeness

I went to this website and entered the model number and looked at the parts illustrations for the part I needed. Which was really helpful since I didn't know what the part was called. So to have this visual was really helpful. I ordered it and received it in less than 3 days and it took me less than 5 minutes to replace the part! I broke this part about 3 years ago and it looked horrible. This was so easy that I don't know why I waited so long to replace it. This is the second time I've ordered from this company and I would totally recommend this company to anyone!

remove 2 phillips screws from old canopy mica then a mixing fan and plastic retainer will fallout that holds the mixing fan in place. To install new canopy mica take your fingernail or something and scrap the three melted posts on the retainer that fits in new canopy mica on the retainer. If it is loose use a small amount of super glue to attach to new conopy mica to the retainer.Guide mica and glued retainer with fan up onto the post that runs the mixing fan.slide the right side corners in slots and tighten scews.preheat oven and good to go.

bought a fuse but that didn't solve the problem. Guess I need a new microwave

Replaced the cord, attached it to the light fixture, and then replaced the cover for the bottom of the appliance

I myself had difficulties replacing bulbs, as I have no feelings in my fingers, so I asked my son while holding the bulb in the bubble wrap, He had no problems what so ever.

Removed tiny screw from under the microwave that held the lid shut where the light was located. Took out old bulb and replaced with new one. Very easy!!!!

PartSelect had helpful repair instructions on-line which made the repair easier and faster. Unfortunately, there were other problems with the oven that immediately blew the new fuse I had just installed. It was then determined that additional repair would most likely cost almost as much as a new microwave.

After reading reviews that there was no power what so ever and a fuse replacement will solve the problem, I tried it. Replacing the fuse is very easy (and I am not handy at all). All you have to do is remove the microwave cover from the top by removing two screws, slide the cover to the left and pulling the cover off. Then remove the grill in front of you, by removing one or two screws. The fuse is in front of you, use pliers and be firm but gentle. Replacing the fuse is easy but it did not solve my problem.