JVM130KC02 General Electric Microwave - Instructions

Remove light cover. Replace bulbs Note. Light bulbs are 40W,Too much heat for bulbs & sockets

My son had to replace the bulbs because the screw that holds the bulb shield was so tight that I couldn't remove it. It was too difficult for me to do it myself.

I removed light bulb cover shield,took out defective bulbs and replaced with new ones. 5minute repair

Watched How to repair a Microwave that turns on when the door is opened Video on the web. From this took a shot at the switch was the problem. When I removed the switch it was defective. The small button was in and when you turned the switch upside down the button would drop back into position. Ordered a switch for $25.oo , installed it and the microwave is working fine.

used small screwdrivers to insert behind black door hickey. pried it loose, undid screwa to old handle and SAVED them to put in new handle. Relatively easy.

Microwave would not turn on. Lights and fan worked fine. Before the microwave stopped completely, it would turn the microware fan on even when door was open. I read the reviews and they were exactly the same issue that others were facing. Once I opened the front panel and got to the switches it was easy to figure out which switch was bad as it was the one that was soft (When clicking it). It was hard to take it out though (it seemed stuck). So, I used a plier to yank it out. I put in the new switch and everything worked just great! I would like to thank other comments that were left on the site to make my task much easier. Thank you (to the commenters on PartsSelect), you not only saved me money, but also ensured that I learn about the microwave more and give me the confidence that I could fix it.

I took instant pictures at each step to make sure I put the wires back correctly. Removed the front panel. Discharged the capacitor with a voltage meter. Removed parts in front of the magnetron. Removed and replaced the magnetron. Reassembled. Works find now. Small hands, a flashlight and a magnet (for dropped screws) would help. I did not need the pictures.

We separated the inside of the microwave door from the outside in order to get to the screws. This was the most difficult part of the repair. We got the directions on how to do this from the internet. We did not find the screws too long because there were spacers with the original screws. We found the top spacer put in backwards because the original screws were shorter. After putting the spacer in correctly the screws that came with new part were fine.