All Installation Instructions for Jenn-Air Refrigerator JS42NXFXDW05

Light did not come on (bad bulb!) on TC18KL

I have never before seen a bulb with the filament intact not light. If the bulb's filament seems intact, screw the bulb into a known working lamp and see if it lights. When screwing it back into the socket in the fridge, it takes a bit of extra effort to fully seat (until it does, it won't light!). For replacing the switch, I unplugged the unit, used a paint scraper and worked it under the switch bezel from the right side. A bit of moxie, and the switch came out. The replacement switch had a different spade contact spacing than the original. I used a pair of scissors to cut the rubber bridge between the two switch wire connectors so I could connect to the new switch. In the end, it turned out to be the bulb. NOTE: The Model TC18KL is _not_ listed! What I finally found that the number "P7803211WL" on the sticker is actually a manufacturing code. Found this out by searching, and Sears' part search came up with matches.

Parts Used:

Refrigerator Door Switch

Louis from Beloit, WI
Difficulty Level:
A Bit Difficult
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Filter needed replacement

The repair (really replacement) took less than 2 minutes. You press a button to pop out the old filter and stick the new one in. Easy as pie.

Parts Used:

Whirlpool EveryDrop3 Refrigerator Water Filter

Roy from The Villages, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Ice Maker quit working

Had to Test Seloind. It Was OK. Then tested Motor Motor For Ice Maker. It Was Bad. Went Online Looked Up Parts For My Unit. They Were Shipped in a Timely Manner, only a few days. Installed parts in less than 15 minutes. Went very easy. Thank You

Parts Used:

Icemaker Motor Kit

David from Castalia, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

No light in frig

We tried repairing with a new switch which was very easy to install but it didn't fix the problem.

Parts Used:

Refrigerator Door Switch

Irene from Whitehall, MT
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

no problem, just needed to change the filter

Removed the old one and installed the new one

Parts Used:

Whirlpool EveryDrop3 Refrigerator Water Filter

Ruth from Katy, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Water Filter Needed To Be Replaced.

Removed old water filter by simply twisting the the cap that houses it at the bottom of the refrigerator and replaced with new water filter. No fuss, no muss! Very impressed. Also, I was quite pleased to have received the water filter that was designed specifically for the whirlpool model that I own. I expected to receive some generic-type model based upon the reasonable price that I paid. Kudos to partselect!

Parts Used:

Whirlpool EveryDrop3 Refrigerator Water Filter

D'Joane from Union City, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Light switch which turns on the lights when the door opens went out

This is an easy fix, simply remove and replace. What I was impressed with is that a how to video was provided along with my part. I wish all manufactures would offer this, the video was easy to understand and you had a good view of the operation. Thanks, a job well done.

Parts Used:

Refrigerator Door Switch

Dennis from Lawrenceville, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

Was this instruction helpful to you?

water filter replacement

Just had to take the old one out and put the new one in. No problem.

Parts Used:

Whirlpool EveryDrop3 Refrigerator Water Filter

Phyllis from Joliet, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Light switch went bad

Simply stick a putty knife between the switch and refrig wall. Pop out old swith, remove both wires by pulling off switch by terminals. Throw switch out. Put wires on new switch and push into slot and all done. Nothing to it! Took me 5 minutes if th

Parts Used:

Refrigerator Door Switch

Joseph T. from Morgantown, WV
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Filter needed to be replaced

Pulled out the old filter with the push of a button, removed filter cover from frig, took covers off the end of new filter and pushed it into the slot replaced cover. Job done--1 minute.

Parts Used:

Whirlpool EveryDrop3 Refrigerator Water Filter

Bryan from Raleigh, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

plastic stopper came off arm

with a mirror to see the small hole on the front side of the icemaker.... very simple, took 1 minute

Parts Used:

Refrigerator Armshut

TinTina from Bruce, WI
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Freezer temperature too cold

Temperature in freezer too cold. Temperature display showed higher temperature than actual which caused the freezer to continually run. Thermister is found behind a white box on wall in freezer. Unscrew the box from wall and easily disconnect the thermistor clamp. Replace in reverse order.

Parts Used:

Thermistor

Robert from Boynton Beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

Was this instruction helpful to you?

light would come on and off

Viewed the viedo - it showed what to do

Parts Used:

Refrigerator Door Switch

Dora from Rock Island, IL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Water filter cap on my Whirlpool refrigerator was inadvertently disposed of in one of my earliest filter change efforts. I needed to replace it for esthetics and personal peace of mind.

Ordered the replacement filter cap. Received it, cut open plastic shipping envelope after unsuccessful attempts to tear envelope by hand, snapped cap in place; Wallaah, project completed successfully!!!

Parts Used: