JS2428GEHB (PJS2428GHB0) Jenn-Air Refrigerator - Instructions

Pried out old Switch,Hooked wires to new switch Snapped in New Unit.
5 minutes Total Time

parts select made it so easy.....great delivery in a short amount of time.

Removed old light switch by prying up and out of housing...removed wires (carefully not to get shocked!) and taped to inside of refrigerator housing. Ordered best matching part and rec'd it in a couple of days. Took less than 5 minutes to remove taped wires from side of cabinet and connect to new switch (which was a perfect match to the original equipment) and snap switch back into refrigerator housing! Works perfectly! Thanks!

removed top hinge, lifted door off bottom hinge, replaced cam, installed door.

replaced drain hose; melted ice that had built up behind it

I followed the other web notes with one change .Since I too forgot the lube , I used a pry bar and block of wood to lift the door and a tooth pick to glob some lube in the lower hinge.

Removed ice bucket, removed front of old ice bucker, removed ice auger, steralized new bucket and replaced all parts. Slid new bucket in refrig.

Removed the top hinge (4 screws)-lifted the door off of the lower hinge-replaced both halves of the cam kit and mounted the door and reattached the upper hinge.
Probably took about fifteen minutes total.

removed ice bin from the fridge. snaped off the front plate. Removed 4 screws. this led to freeing up the auger. removed it and put the auger into the new bin and replace the front parts. Put storage bin back into fridge. Done. Might want to keep some ice cubes in a separte container until done. Not hard.

The worst part was unloading the door shelves. Removed upper hinge cover and hinge hex screws. This allows the door to be removed. Lay the door on side. Remove screw that holds cam in place. Replace
broken cam with new piece. Put the door back on the hinge pin and replace upper hinge screws and cover.
Now reload all of the stuff.

Remove the grandkids pictures from the door then empty the contents inside the door. Remove the top hinge cover and the top hinge bracket. Lift the door off the bottom pivot. Replace the lower cam by removing one screw. With the door in the horizontal position, remove and replace the upper cam. Apply a little grease on both cam surfaces. Align the door before tightening the top bracket and your done. If you did not take a picture of the door before you started the project you will have to rely on memory to arrange the pictures in the proper location.

Removed the old one put in a new one, fairly simple. Would have been much easier if I had called the manufacturer first then ordered the part. The first part I ordered was the ice bucket, I thought I was getting the crusher mechanism, but it turned out to be the bucket only. When I finally got the right part it was really easy. I went ahead and kept the new bucket anyway.

Just removed old parts and replaced with new parts

Took the door off, and replaced the plastic shim on the bottom that was the cause of the problem. The shim had broken into pieces and was no longer holding the door in height and alignment. I was proud of myself that I could repair it myself and avoid a $125.00 service call from a repairman. Total cost of repair including shipping and handling was just south of $12.00.

Just put the dairy tray were I wanted it. Will do the same with the crisper drawer when it arrives.