JNM1541DM4BB General Electric Microwave - Instructions

1. Removed the plastic rivet holding the stirrer fan cover in place.
2. Slipped a small pry bar under the cover to allow room to grip the cover and pull it out of its setting.
3. Removed the stirrer fan and placed in new cover.
4. Disposed of old rivet and cover.
5. Aligned new cover with rivet hole and pushed it up and into place.
6. The rivet comes in two (2) pieces: the actual rivet and a locking collar.
7. Pushed the rivet locking collar in place and pushed rivet into the collar.

Using some help, removed the above the range microwave. Took apart parts of the microwave to get to the magnetron. Removed existing magnetron, inserted the new magnetron. Put the microwave back together. Tested the microwave to insure the magnetron was working before reinstalling. It did heat. Then reinstalled it back above the range.

Moved the stove from underneath the microwave. Took the microwave down and turned it over. this need not be done. took the screws out to remove the bottom panel. there is a quick disconnect that need to be opened up. used pliers to remove the bad sockets and installed new one, used pliers to seat them. put bottom panel on, hooked up the quick connect. put the screws in and tightened them. installed bulbs and hooked up the electric and turned the lights on, they worked. installed the microwave, slid the stove back in place.

Unscrewed the vent at top of microwave exposing small access to bulb. The access to this was very limited so that was the major issue in changing the bulb. You needed small hands to do the job.

Took off plastic around inside the door , took broken latch off and put spring on new latch on plactic on and it works . ????

Gently remove plastic rivet holding cover in place.Rotate cover slightly and pull down. Remove stirrer fan from old cover and place on new cover. Place cover back in microwave and rotate till rivet hole lines up and replace rivet. Done.

The tray came within 5 days and I simply took it out of its well-packaged box and slipped it into my microwave. It is working just like new. I can't thank you all for being so punctual and reliable. better than having to buy a brand new microwave.

Remove pin and shift old cover plate clockwise to release cover. Remove and insert fan into new cover and replace cover by inserting cover plate tabs and turning counter clockwise. Insert new pin to connect new cover plate.

Took off vent cover and front panel, replaced switches.

Open the microwave door. On the outer edge the is a 1 inch thick black mold that goes around the entire door. Pry that back with a flat head screwdriver where the handle is and you will see the 2 phillip screws are exposed, top and bottom. Remove them..

Required removing the old unit and disconnecting the exhaust ductwork and drilling new holes for attachment to the cabinet

I had already removed the old grease filters. Unwrapped the new grease filters and popped into place. No tools were necessary.

Replaced the dead motor with new motor . I used YouTube video to install.

Simply popped the turntable shaft in. It was installed by hand, no tools required.

I unplugged the appliance first. It was an over the range microwave so I only opened the front part where the buttons are, and behind it there’s a set of 3 door switches, carefully took out the burned down one and replaced it.