JFC2290REP02 Maytag Refrigerator - Instructions

took old one out installed new turn left out turn right in

Used screw driver to pop out old switch. Used pliers to hold wire connection from fall back into slot on fridge. Inserted new swith into plug and pressed new switch back in place.

Dropped down the housing for the water filter, twisted, removed item and slotted in the new filter. Easy as pie.

Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discoloring refer handles. Thank you

I had several times tried to get the old switch out but with no success. Ordered the "repair kit" and followed directions for removing old switch (there is a plastic spring clip on one side). Easy to unplug the old switch, plug the leads into the new one, snap the new one into place. Took about 5 minutes total--piece of cake. I wish I'd thought to try this years ago when the old switch began to fail.

After months of glueing and re-glueing the piece back together, I searched online using the product numbers on the back of the part. I found this website instantly and the replacement part. When I ordered the part I was concerned that it would not fit but it fit perfectly and the repair cost $20. I had a great experience with this site and will use it again.

Piece of cake. Took out old filer and put in new one!

Opened filter area door turned old filter to the left to unscrew. Took out old filter then replaced the new filter and turned it to the right to tighten it, closed cover and that was it all done.

I turned the water supply off and installed the new filter, which was easy. the hard part was finding the water filter at my local home improvement stores; they don't carry it. In the future I will use only Part Select.

Pried out the old switch with small screwdriver, popped in the new one and tah-dah!! ..the light came on. While I was at it, I cleaned out the freezer :). I cannot begin to imagine what a repairman would have charged for this.

It was a breeze once I figured out how to remove the old part. Everything snaps together no tools required and I'm sure I saved myself a bundle by doing it myself.

Unplugged appliance. Using a small putty knife I moved the switch out far enough to grab it with pliers. Moved wiring to new switch and pushed into place after testing.

Simply remove the filter and insert the bypass cap in its place. Cap turned a little hard but if your careful everything goes together easily.

So simple I couldn't believe it! Twist out the old filter then twist in the new! Easy Peasy!

Thought I needed a new filter. Did not solve the problem. I returned the filter to partselect as per instructions. Will order from partselect when I need parts.