IRH32001 Inglis Microwave - Instructions

Glass plate arrived in less than two days. Placed the glass plate in Microwave and presto the microwave works like a charm.

submitted manufacturer info to website and voila! a new glass turntable arrived in 2 days. I don't do well with computers, my 23 yr. old daughter was impressed......couldn't be easier! thanx! will definitely revisit your site

Removed screws holding tabs from broken vent grill to microwave frame.

Carefully snapped new grill vent into slots on top of microwave and slid tabs into slots on top of the frame.

Replaced the two screws in the tabs.

Finished

All I had to do was open the microwave door and place the turntable on the designated grooves, wha lah it fit. I am now back in business. Thanks to partselect, I found my replacement, ordered and it was shipped in no time.

I remove the old broken Grill Vent by loosing two screws and just put the new one and adjusted with the same two screws.

I simply removed the original 2 screws for the old grill, attached the new grill, fastened it with the original screws & It fit perfectly in less than 5 minutes time.

old vent off screwed new in less than a minute

I, carefully, inserted the bottom tabs into the appropriate slots. I then rotated the vent piece up and into place under the top lip of the Microwave. Once positioned I installed the screws required to hold the piece in place. Very simple replacement. It gave me a chance to clean the grease behind the vent.

I removed the broken tabs with a screwdriver and snaped in the new cover replacing the screws once I had it in place. the entire job took less than 5 min.

took old vent grill and tabs off using phillip screwdriver. started putting new grill on and it wouldnt go on. got to looking and there are two more screws that you have to loosen up so the grill will go into place these two screws are between the two tabs at each end. caution do not over tighten the screws it will break the tabs. overall easy to install.

Replaced vent with 2 screws. Very easy.

Take out the screws, broken pieces of clip, then put in the new vent grill, replace the screws. Done!

put the turntable in and had a Rum and Coke to celebrate. Your service was GREATTTTTT...

First remove two screws on top of microwave. Pull off old vent grill. Finally line up new vent grill (bottom edge first) then snap into place. Replace two screws on top of microwave.

This was a piece of cake! Less than 48 hours to get the part and 3 minutes to find and return the screwdriver and 3 to make the repair! I removed two screws, the old grill and then set the new grill in place and rescrewed the screws.