HTC12 - Overview
Models starting with HTC12
Click on the best match to narrow your results.
- HTC12 Homelite Tiller (Homelite Tiller Model HTC12 Parts)
- HTC12 (UT-22089-B) Homelite Trimmer (Htc12 Hedge Trimmer Ut-22089-B 22089-B-Ut Htc12 Hedge Trimmer Ut-22089-B Htc12 Hedge Trimmer)
- HTC12 (UT-22089-C) Homelite Trimmer (Htc12 Hedge Trimmer Ut-22089-C 22089-C-Ut Htc12 Hedge Trimmer Ut-22089-C Htc12 Hedge Trimmer)
- HTC12 (UT-22089) Homelite Tiller (Tiller)
- HTC1244W General Electric Microwave
- HTC1246W General Electric Microwave
Keep searches simple, eg. "belt" or "pump".
Primary Door Interlock Switch
PartSelect #: PS237015
Manufacturer #: WB24X10047
This interlock switch is located in the door latch.
$54.49
Special Order
Screw - Sems Hex (10-24 X 2-1/
PartSelect #: PS9989484
Manufacturer #: 660673001
$5.95
Special Order
Tubing - Rubber (3 X 3/4)
PartSelect #: PS9867183
Manufacturer #: 0143916
A genuine item which is supplied by the original equipment manufacturer for use with Homelite string trimmers. It is one of the special tubes utilized to transfer fuel between the carburetor and the t...
$5.95
Special Order
Clamp- Wire
PartSelect #: PS9997429
Manufacturer #: 690765001
This is a genuine Homelite replacement part designed for use with String Trimmer and Blowers. The purpose of the wire clamp is to secure the fuel line to the filter. It is made out of metal and it is ...
$5.95
Special Order
Screw Slotted Hex Hd 1/4-20 X 1/2"
PartSelect #: PS9866804
Manufacturer #: 0107580
$6.95
Special Order
Common Symptoms of models starting with HTC12
[Viewing 4 of 4]Won’t turn on
Fixed by
these parts
these parts
Show All
No heat
Fixed by
these parts
these parts
Show All
Doesn’t shut off
Fixed by
these parts
these parts
Show All
Tray won’t turn
Fixed by
these parts
these parts
Show All
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Microwave would turn on and count down, but not heating and not rotate turntable. Pressing door up would occasionally start heat.
First I disconnected the power and opened the door. Then I removed the top screws holding the top vent louvers, then removed the screw at the top of the touch pad. The touch pad removes by sliding up slightly then tilting top out. I unscrewed two screws holding the door latch assembly. Press the tab to remove and replace switch. Reconnect wires, reseat latch mount by placing top bracket tab in place first, allign and secure with screws. Reseat touch pad by placing bottom tabs in first, tilt forward and press up to seat top tabs, secure with top screw. Secure vent louver screws, plug in and watch your microwave work again.
Parts Used:
-
Michael from Ridgefield, CT
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
40 of 67 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Microwave runs with the door open
Remove microwave outer cover. Turn on side & locate the upper & lower door switches. Better to replace in pairs even if one is ok. Remove the wire harness to each switch. Then replace switch and re connect the wire harness. Re attach outer cover
and test to see if that solved the problem. If so then well done!!
and test to see if that solved the problem. If so then well done!!
Parts Used:
-
Thomas from Andover, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Screw drivers
37 of 58 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Everything seemed to work with the controls, but when you pressed start the light would come on and nothing else. The turntable and heating system would not function.
I unplugged it, removed the outer shell with torque bits and a screwdriver, drained the main capacitor, and began debugging the circuit with my fluke multimeter, found the bad primary interlock, googled the part number, ordered the part, received it in 2 days, replaced the interlock in about 2 minutes, and put the cover back on. Fixed. Saved me about $200 over buying a new unit and was grateful for partselect's great service.
-Keith Packard
-Keith Packard
Parts Used:
-
Keith from Bowling Green, KY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
25 of 43 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!