GTDS560EF2WS General Electric Dryer - Instructions

Remove the old bearing assembly and Replaced with the new bearing assembly with new bearing slides.

I followed the video instructions provided to me by this site

Unplugged power to dryer. Opened door and removed the two screws that hold the top panel on. Removed top panel and set aside. Then removed the two screws that hold the front panel secure and leaned front panel towards me. Replaced parts with absolutely no tools. Reverse steps to assemble dryer. The videos are very informative and give you the confidence you need to do it yourself.

I followed the instructional video that was given online. The parts fit well, and was easy to repair.

Called my son-in-law. Easy as pie

Removed two screws, lifted the top, removed two more screws and tilted the front panel. The worn parts were accessible, and I simply placed the new parts in. It worked. A little trouble placing the top back in the slots, but a fist whack did the job.

Removed two screws inside the door at the top of the frame. This allowed the top to be lifted and slid to the left a bit which allowed the front of the dryer to be removed. The Drum Bearing was held on with plastic tabs and the Bearing slides just fitted over a small tab then into a slot. There is a "knockout" for the light which is removed. The entire process took less than 15 minutes.

Simple. Followed the well organized instructions on the youtube video and it was done in a jiffy! Saved me hundreds of dollars since I didn't need a repair man and my purchased/replaced parts prevented me from having to buy a new dryer!! Thank you!!

TOOK OFF TOP AND FRONT PANEL REACHED IN UNDER TUBE AND REMOVED FROM BELT TENSIONER HARDEST PART IS PUTTING BACK ON TENSIONER TAKES TWO HANDS LAYING ON YOUR BELLY

I simply followed the how to videos. No need to deviate from those.

I followed the step by step instructions provided by Video! Very informative, easy to understand and follow! If I can do it myself, anyone can! Thank you !

2 Screws hold top on, removed top, 2 more screws hold front panel with door on, removed front panel. Unclipped front drum bearing installed new one with new sliders put back together.

I first watched the video provided on the web site to confirm the steps to repair. Simply remove two screws and lift off the top to gain access to the two screws that hold the front. I didn't need to unplug the wiring harness - just fold the dryer front sideways 90 degrees and have plenty room to work. From there it is just unplug the old parts and plug in the new. Everyone else may know this, but there are TWO green bearing slides and TWO white slides on my model. I only ordered one of each the first time. The second time is much easier!!

Take out the two screws holding the top on with the door open remove top and remove two small screws in top front corners. I replaced the 4 slides and the drum bearing without the new felt, do not do this it continued to squeek after it ran the first few times when i got the new felt a week later i installed it in ten minuites and the noise is gone. I think it cost around sixty dollars and my dryer is back in action. Make sure that you clean all of the lint out of the inside of your dryer I had alot of build up near the chute for the lint trap.

I read the repairs that others had posted and how they did it. It was really easy. My only complaint is that I didn't know that I needed the slides that attached to the bearing and couldn't find them on the repair list. My dryer had a spot for 4 of them and only 1 was left. Otherwise, being a female, I felt great to be able to fix it myself! Thanks!
Let me also say, I only have one good working arm/hand.