GHW9100LW1 Whirlpool Washer - Instructions

Exact fit VERY GOOD Quality would order any part
again

The baffle just slipped on with no tools required. The best thing was that we received our parts the next day after ordering them, and we just paid for regular shipping!

the old handle was held in place with two screws.
the screws were removed, handle came off right away and then the new handle was place on the door and the screws were replaced.

Simple. Found my torx bits, removed the screws, removed the old handle, placed the new handle in position, replaced screws.

This happened because I failed to wait for the click on the machine before I opened the door. It's a front loader and it needs time to drain the water before you open the door.

First, I unscrewed the two screws on the broken handle, using an allen wrench. Then, I screwed on the new handle in it's place. The new grey handle is much lighter in color than the original charcoal grey of the washer, but it blends well and works perfectly.

As easy as 123 two torx screws removed old pieces and install the new one and like that ready for another 15 years.

Repair was described as a simple 5 minute job following the enclosed directions. There were no directions included. Customer service replied they could not provide any instructions. I located a technical manual online and determined the steps necessary to replace the baffles. While some may just click them in, a proper repair requires the control pannel and machine housing to be removed. Then the tub assembly must be removed and the plastic tub separated from the basket. Three screws (one for each baffle must be installed. (I recommend using blue loctite to keep the screws from backing out). The entire process must then be reversed. This is a slightly complicated (note the pencil is to mark the locations of clips for ease of reinstallation. I am an Engineer and this process took over 2 hours and required a significant amount of space to lay out the parts as the machine was totally disassembled. This assembly is best accomplished with 2 people and an entire afternoon without interruption. It can be done by anyone with some mechanical skills, but find the consumer services technical manual first and be prepared to keep track of a lot of small and large parts. This is not the simple 5 minute job described by others (unless you just want to snap the baffles on the basket and not lock them down). In that case go ahead and order a few more sets as the clips will break and the baffles will slide off and you will be replacing them about every 6 months.

disconect wayer inlet hoses.remove screws that hold the top cover. This will expose the water inlet valve. remove the defective valve and any other associated clamps,hose etc. test run for leaks.

Unscrew old one,screw on new one

Two screws. Take off old handle. Put on new handle.

Ordered the part. When it came we needed to find the correct screwdriver because the screw did not work with philips head screwdriver. We used slotted even though it wasn't that type of screw. It worked just fine and installed very easily. It worked great.

First I waited 6 days after i was E-mailed the part was shipped until it was shipped, then waited two more days to get the part!
Then i removed two TORX screws removed old handle then installed the new one in reverse order.

I unscrewed thebolts from the old handle using a small flat screwdriver and removed the cracked handle. I then tossed away all the old duct tape holding the old handle together. Replaced new handle using same old bolts.Strongly cautioned children and husband to not wrench the washer handle open and closed. Tah Dah! Done.

I removed two screws and removed broken piece and replaced the handle with the same two screws. The color and match of the handle was perfect.

Took two screws out, removed broken handle, replaced with new handle and put two screws back in. Ridiculously easy. :)