All Installation Instructions for General Electric Refrigerator GFSS6KEXESS

water filter was aged and needed a replacement

unscrew filter and replace the new one

Parts Used:

Refrigerator Ice and Water Filter

Richard from La Grande, OR
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

replaced filter

none required

Parts Used:

Refrigerator Ice and Water Filter

donnie from metairie, LA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

on the french doors my granddaughter kept turning the inner seal bar when the door was open and when we went to close it it was in the wrong position and eventually the upper hinge broke

I took a small straight screw driver and popped the cap case off, removed old hinge and installed new hinge and snapped the cap back in place.. took all of 30 seconds

Parts Used:

French Door Hinge

CAP CASE FRENCH

david from bridge city, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Thank you for voting!

Spring broke

Installed new spring pin and spring. Took only 2-3 minutes. It was more difficult to get the correct part since the spring pin was the only number listed in the part diagram and I actually needed the spring and had to call customer service to get the correct part number.

Parts Used:

French Spring Pin

Sharol from Culdesac, ID
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Water filter needed replacement

Removed the old filter. Filled the new one with water and put it in theplace of an old one. Flushed the system with 1 gallon of water.

Parts Used:

Refrigerator Ice and Water Filter

Natalia from Mount Pleasant, SC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Broken plastic shelf cover

took shelf out, put back in! EAsy

Parts Used:

Upper Door Bin

Michele from Birmingham, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Poor water and ice taste, filter a few years old.

Very simple, I followed instructions sent with the filter. Twisted old filter clockwise 1/4 turn to remove. Filled new filter with water, lined up arrow on filter to arrow on refrigerator, and then turned 1/4 turn counterclockwise. Filter raised and seated itself. Wiped few drops of water from refrigerator shelf.

Parts Used:

Refrigerator Ice and Water Filter

David from San Antonio, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

We needed a new water filter.

We received the part just a few days after ordering, unscrewed the old filter by hand, and installed the new filter the same way.

Parts Used:

Refrigerator Ice and Water Filter

Dan from Surprise, AZ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Filter needed replacing

Folowed instructions

Parts Used:

Refrigerator Ice and Water Filter

W Craig from Diamondhead, MS
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Thank you for voting!

Factory installed rail was overtightened and fractured the rail. Subsequent use resulted in rail failure.

Remove drawers and internal shelf supported by rail(no tools). Remove rail (phillips). Remove roller from existing rail. Intall roller on new rail. Install new rail (phillips). Replace shelf and drawers. Note: New roller (identified as a separate part) and screws are not included with rail.

Parts Used: