Models > GFSF6KEXCBB > Instructions

GFSF6KEXCBB General Electric Refrigerator - Instructions

All Instructions for the GFSF6KEXCBB
46 - 60 of 75
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Needed new water and ice filter
simply read the instructions
Parts Used:
Refrigerator Ice and Water Filter
  • Marilyn from Green Valley, AZ
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Ice and Water Filter needed replacement
I watched the video, and noticed that they did not even turn off the water. The replacement took less than 30 seconds once the filter was filled with water.
Parts Used:
Refrigerator Ice and Water Filter
  • Tim from Fort Worth, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Brokjen spring
Lifted out the broken part and replaced with new spring.
Parts Used:
Door Mullion Spring
  • Sharol from Culdesac, ID
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
no turn on
with my hands
Parts Used:
Refrigerator Ice and Water Filter
  • edward from orlando, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Nutdriver, Screw drivers
0 of 1 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
french spring broke
after receiving spring installed spring in seconds. Thanks partselect.com Ryan Cappell
Parts Used:
Door Mullion Spring
  • RYAN from RIVERBANK, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Pliers
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Light burnt out.
Turned the wire protector to the side. Turned out the old bulb and replaced it with the new. Turned the wire protector back in place and I'm like new.
Parts Used:
Light Bulb - 40W
  • Roscoe G from ROCHESTER, NY
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
2 of 8 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
filter change
easy easy easy!!!!!
Parts Used:
Refrigerator Ice and Water Filter
  • Mary from Elk Grove, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
1 of 5 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
water tasted funny
Simply twisted off the old water filter, unwrapped the new one and twisted it on.
Parts Used:
Refrigerator Ice and Water Filter
  • Charles from Enterprise, AL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 2 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
needed to replace the filter
replaced the filter with the new one i purchased
Parts Used:
Refrigerator Ice and Water Filter
  • richard from asheboro, NC
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
0 of 3 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
French spring broke.
pushed new spring in.
Parts Used:
Door Mullion Spring
  • Andrew from Bensalem, PA
  • Difficulty Level:
    Very Easy
  • Total Repair Time:
    Less than 15 mins
6 of 26 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Evaporator Fan Failure
Disconnect power to refrigerator, Removed all upper shelving, slid the draw assemblies out 12 inches to gain access to lower retaining screws using my power screwdriver. Removed three lower retaining screws and two screws that hold the center shelf rail. Then removed the cover assembly by pulling out and down from the bottom of the assembly until I could access the connectors for the fan at the upper left hand corner. After releasing the lock tabs for the electrical connectors I removed the assembly from the refrigerator cabinet. There was an excessive amount of ice/frost buildup due to the fan failing so I used a blow dryer set on low to thaw the ice from the evap coils and related wiring and sensors. Once thawed and free from ice, I reversed the procedure to install the new cover. The procedure would have only taken about 10 minutes if it were not for the ice buildup. I would recommend letting the frig thaw first if you have another place to store the food. Overall, very easy to install.
Parts Used:
Assembly COVER-EVAP REF
  • Fran from Mount Vernon, IA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The plastic on the vegetable tray shelf was cracked
The repair was so easy. I had to take out all the food. Then I was able to easily lift the shelf out, and put the new shelf in and replace the vegetable drawers.
Parts Used:
Vegetable Pan Cover and Glass Assembly Refrigerator Ice and Water Filter
  • Karen from Medford, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
Was this instruction helpful to you?
Thank you for voting!
Evaporator freeze up
Pulled off the evaporator cover and replaced the Temp sensor.
Parts Used:
Assembly TEMP SENSOR
  • Peter from Homer Glen, IL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
replaced filter
none required
Parts Used:
Refrigerator Ice and Water Filter
  • donnie from metairie, LA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
on the french doors my granddaughter kept turning the inner seal bar when the door was open and when we went to close it it was in the wrong position and eventually the upper hinge broke
I took a small straight screw driver and popped the cap case off, removed old hinge and installed new hinge and snapped the cap back in place.. took all of 30 seconds
Parts Used:
French Door Hinge CAP CASE FRENCH
  • david from bridge city, TX
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the GFSF6KEXCBB
46 - 60 of 75