All Installation Instructions for Frigidaire Range FFEF4015LWC

Range had been dropped

Removed both sides, removed ceramic glass surface, disconnected surface wiring.
Replaced Small oven Latch, replaced both sides and storage drawer.
reconnected wiring, replaced control panel end covers

Parts Used:

Levelling Leg with Rubber Pad

LATCH

Phil from Playadelery, CA
Difficulty Level:
Difficult
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Socket set

0 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Broken globe in oven and burnt out light bulb

Easy as 1-2-3

Parts Used:

LENS

Light Bulb

Sharon from Foley, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Bake element went out on my oven

Took a screwdriver and removed screws attaching the element to the back of oven. Disconnectec the wires from the old bake element. Replaced the new reversing the process. Very easy.

Parts Used:

Oven Bake Element

Jeffery from Union Point, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

missing rack

slid it in

Parts Used:

Oven Rack

Constantine from Vero Beach, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Burner on top occasionally went to high heat though it was set at low

Replaced the switch...removed old switch and transferred the wires one at a time to the new switch. Seems to working fine..

Parts Used:

SWITCH

Kathleen from Lawrenceville, GA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

burner burned out

unplugged old burner plugged new one in

Parts Used:

Surface Element - 8 Inch - 2600W

Charles from Kettlersville, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Coil melted in half.

First. shut off the power!!! Remove the two screws holding the coil. Next- slightly pull remaining wire to access the plugs. Unplug the wires, remove old coil, replace and plug in the new... Replace two screws.... Turn power on and....... Start cooking! EASY!

Parts Used:

Oven Bake Element

Gerald from Artesia, NM
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

Replaced burner drip bowl

Very easy to remove the old drip bowl and replace with new ones.

Parts Used:

Chrome Drip Bowl - 6"

Drip Bowl - 8"

Irene from Rochester, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Needed new drip bowls

The hardest part of the job was cleaning under the old rings. Cook top looks new again!

Parts Used:

Chrome Drip Bowl - 6"

Drip Bowl - 8"

Judith from Jewell, IA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

Could not find drip plates in local stores

Just put the drip plates in stovetop and worked perfectly

Parts Used:

Chrome Drip Bowl - 6"

Drip Bowl - 8"

Pat from Hendersonville, NC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

element not heating right

Took old one out and plugged the new one into place.

Parts Used:

Surface Element - 8 Inch - 2600W

sharon from Summerton, SC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

8" left front surface element would no longer heat properly

I ordered the exact replacement element, and after unpacking it, it took about 5 minutes (actually,less; didn't time it), and the new element was installed and working fine.Thank you very much.

Parts Used:

Surface Element - 8 Inch - 2600W