All Installation Instructions for General Electric Dryer DCCD330ED3WC

Squeaky dryer

I followed the YouTube video and it gave me step by step instructions however I really needed to replace my dryer slides to fix the problem.

Parts Used:

Rear Drum Bearing Kit

Shelly from MURFREESBORO, TN
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Socket set

1 person found this instruction helpful.

Was this instruction helpful to you?

The door handle was comming off had broken hook

I pulled the old handle off and pushed the new one on.
No problem at all.

Parts Used:

Door Handle - White

John C. from Cincinnati, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

dryer belt snapped

Replaced it as one would. I took off the front facing and replaced the belt. It took a bit of searching to find the proper way to route the belt around the pulley.

It took a while since it was my first time and I wasn't sure what to take apart and what to leave intact.

If I were to do it again, it would take 30 minutes or less.

Parts Used:

Drive Belt

Michael from Laurel Springs, NJ
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

3 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Cracked air duct

Two screws under the dryer door then the top comes off.Then two screws hold the front on come out. 4 screws top is off and front is off the rest is no problem.

Parts Used:

Dryer Lint Chute Assembly

Forrest from Mays Landing, NJ
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

2 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Dryer needed a new dryer belt

I followed the directions I found on my tablet on youtube.

Parts Used:

Drive Belt

Cindy from EPHRATA, PA
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Pliers, Screw drivers, Wrench set

1 person found this instruction helpful.

Was this instruction helpful to you?

drive belt is broken.

Follow the instructions from YOUTUBE to replace the new drive belt..

Parts Used:

Drive Belt

Phuc from WOODBRIDGE, VA
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Drum was squeaking and making a lot of noise!

Took apart the dryer housing fairly quickly, pulled out the drum, and installed the kit. Was fairly simple. Then reassembled. The hardest part was trying to get the belt on properly and reconnect to the motor. Believe it or not, I wasted most of my time on the belt. Should've watched the video better and listened to my wife and her suggestions.

Parts Used:

Rear Drum Bearing Kit

Timothy from Rochester, NY
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Pliers, Screw drivers, Wrench set

1 person found this instruction helpful.

Was this instruction helpful to you?

squeeking

Looked at the diagram on your web site and replaced part

Parts Used:

Front Drum Bearing

Gary from Chesnee, SC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Squeaking noise

Dryer was making a horrible noise. When I took it apart I noticed that the from side dryer bearing was ruined. Ordered the part with the slide bars and replaced...Works great...

Parts Used:

Front Drum Bearing

DRYER FRONT BEARING WHITE 2PK

robert from woodstock, GA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

My last phase of repairs of minor items.

if your unit has over 6,000 hours of operations, one needs to remove the front panel and inspect the sliders that the drum rides on. The video were very helpful to replace the sliders. Unfortunately, my dryer had over 10,000 hours of operations over a 30 years period, hence a major repair costing over $200.00 dollars. The drum sliders were gone, hence the drum eat through the plastic guides. More so, the drum started to eat away the front panel. If the dryer is eating your closes and making a noise, one is looking at a $200.00 repair job. Hence check the sliders early will save one $$$$.

Parts Used:

Dryer Lint Chute Assembly