D28111-B2 (3) DeWALT Grinder - Parts

Bearing Cup The bearing cup is an OEM sourced part that is used with Craftsman angle grinders. This is not an aftermarket imitation part. This item is used to secure the bearing on the commutator side of the arma... Add to cart

Bar Add to cart

Arm This is a genuine Dewalt replacement part, it is sold individually. The 648743-00 acts as brush holder for the models listed below. The 636760-00 Brush Spring is positioned behind this part to keep th... Add to cart

Brush If your DeWalt tool is running rough, losing power, or not starting at all, it might be time to replace the carbon brushes. These small but essential parts help power the motor and are one of the most... Add to cart

Pinion It is a genuine DeWALT component which is specially designed for use with grinders. The pinion is an important part of the unit which helps to drive the shaft. Unfortunately, over time it may wear out... Add to cart

Wrench This replacement wrench is a genuine high quality item that is specially designed for Dewalt grinders. This spanner wrench allows user to secure or remove the flange nut which holds the grinding disk....

Brush Spring This coil type brush spring is a genuine DeWalt replacement part. This part is sold individually. As the carbon brush gradually wears away, the brush spring decompresses to keep the brush pressed aga... Add to cart

Cap This is a genuine Dewalt replacement part. It is supplied directly from original equipment manufacturer for use with angle grinders. Brush arm cap hold the felt seal and the brush arm to the grinder. ... Add to cart

Felt Seal Genuine Manufacturer Approved replacement part designed for Dewalt Grinders. This Felt Seal protects the hinge point on the Grinders Brush Arm. This part is made out of Felt and it is Sold Individuall... Add to cart

Terminal This is a genuine item that is supplied by the original manufacturer for use with DeWALT grinders. The purpose of a terminal is to allow a user to easily connect a wire, because this terminal is made ... Add to cart

Felt Seal It is a genuine replacement hardware that is supplied directly from the original manufacturer for use with Dewalt angle grinders. This felt seal fits between the bearing and the bearing retainer, for ... Add to cart

Gasket It is an authentic high quality replacement part that is specially manufactured by Dewalt for use with angle grinders and cut off tools. This gasket provides an air tight seal between the gear case co... Add to cart