CVGX2423W Jenn-Air Cooktop - Instructions

Ordered a replacement grease filter.

First I removed 3 screws that held a plate againt the wires. Then pulled the element out about 3 inches and disconnected the 2 wires holding the old element and connected them to the new element. Replaced the plate with 3 screws and I was done.

Used 5/16 nut driver with 2 sided tape in the inside. Removed old orifice from tape and stuck new one to tape and installed it. Did the same for rest of them.

Removed the part that didn't work and replaced it with the new one

Just placed new filter in slot

removed motor, saw that stablizers were broke and went to a local parts supply shop called SUNDBERG and was given a price of about 49.00 for three stablizers. at that point i went to the internet and found PARTSELECT.COM were i found the same parts for a fraction of the price,17.00, i could not believe it! SUNDBERG customer service was horrible.PARTSELECT custormer service is great and was just over the internet,any how the repair is done no more loud noise and wife is happy again ,for awhile.thanks keep up the good work.i tell everybody about you guys.

took the nuts off &replaced the new ignited

I actually didn't do the repair. I called a service tech, but found it cheaper and faster to order the part myself. It arrived in 2 days. The tech removed the top part of the cook top with a philips screwdriver after that it was easy as unscrewing the valve and replacing it with the new one and tightening it with a wrench. He put the top back on, tightened the screws and that was it.

Needed to remove all 4 burners to repair
one, but it went without a hitch.

Thanks to your exacting and clear diagrams, we were able to locate the correct parts
We called JennAire, but they were unable to
find the part..

It was delivered in a timely fashion and
we were able to finish the job in about
3 hours. thanks

I carefully removed the disgusting old filter and took straight to trash. I then used my wet/dry vacuum to clean the rest of the loose debris from the area where the filter area is located. I used a clean, dry cloth to wipe the remainder of the material away and then carefully lowered the clean new filter down into it's new home. So easy, it took longer to type out these directions :)

very easy slip in

remove two screws then unplug the wires put the wires back on the new one

Purchase the caps and received them within a reasonable short time and just put them right onto the burners. Easy/Breezy

The aluminum threads on the post (part15) can get stripped very easily. If you cannot tighten down the flat nut the clicking will occur.

Took the old filter out and put a new one in. No tools no fuss no muss. Very easy.