CEC4S7WTAA Gibson Range - Instructions

Easy as 1-2-3

Reviewed a YouTube video. Then removed the old element and installed the new one. It was extremely simple! I became my husband's hero instantly!

I have a wonderful range that I love and it is almost 30 years old! The baking element died...burned and broke in half. This is the second time I have had to replace it (not bad for the old girl) and the first time I used PartSelect. I ordered the part late in the day and it was delivered by FedEx in just under 24 hours....now that's service! This is a very easy repair that anyone can do. Just turn power off to range, unscrew the hexagonal screws, ease out the bad element, reattach electrodes to new one, ease it back into range, put screws back in and you are done. Ten minute job you can do yourself for the cost of the part. Great great service from PartSelect.

unscrew disconnect wires put new one on make sure you turn off power

Required taking back of stove off to properly extend the wires to plug in the new element as well as crimping existing plugs to obtain a secure contection.

remove old replace new

At first I used a nutdriver to remove the two inside screws and found that one of the wires were not long enough to disconnect. I had to remove an access panel in the back which only had 5 screws to remove. I took it off, replaced the element and put it all back together. Then my wife tested it by baking an angel food cake which turned out perfect.

The PartsSelect site provided the hint that the baking element might be the root cause of low heat. SO I order the part, got it within a few days and installed it. Simple matter of removing a small read cover and tow faston connectors to the heatng element along with two Phillips screws that secured the heating element. Oven now works like new!! Thanks PartsSelect, you saved me a bundle!

Unplugged stove. Removed oven racks. Using 1/4" nut driver I removed two screws from back wall of oven that were holding bake element in place. Pulled stove from wall, removed lower back panel. Disconnected electric saber connectors. Pulled old element from oven. Put new element in oven. Reinstalled the two 1/4" screws. At the back of the stove, I reconnected the two push-on saber connections. Replaced back panel. Pushed stove back in place. Plugged in the power cord. Checked oven. Works fine.Great experience with Parts Select in every way.Total work time: about 20 minutes.

The wire on one side was stuck in the hole in the back and had to take the back off. It was easy to find and push through. I just connected the two wires to the new element and all was well again.

Husband replaced quickly no problems. This was the first time I have ever received a order so quick...(awesome service)

My husband had no problems except the end of the new element was different than the original, but hooked it up ok!

shut the breaker off , remove the racks' use nut driver to remove the 2 screws, carefully slid the element ends out of the holes, disconnected the wire ends (push on connectors) discarded the old element and replaced with the new in reversed order. very simple

I just watched the video, unplugged the stove, attached the burner and started baking again. DSC

1. Remove two screws securing element to rear wall of oven. 2. Carefully pull element forward until you have access to the wires attached to the element. 3. Carefully pull the push-on connectors from the element. 4. Push wires onto new element. 5. Carefully push element back into oven wall and secure with screws.