All Installation Instructions for General Electric Dishwasher CDT800P2N0S1

Lower dishwasher spinning arm not working

Super easy repair. Took off the spinning arm, removed the Diverter Assembly (no tools required), and reassembled.

Parts Used:

Diverter Assembly

Patricia from Fruita, CO
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

1 person found this instruction helpful.

Was this instruction helpful to you?

System did not come back on after a power failure.

Checked breaker.
Checked power at machine.
Google video was followed to identify the failure was the mother board and not just the display.
Bought and replace board.
Pretty expensive but 1/3 cost of new machine.
Works fine now.

Parts Used:

CONFIGURED MACHINE CONTROL BOARD

Pat from ROBBINSVILLE, NJ
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers

1 person found this instruction helpful.

Was this instruction helpful to you?

Dishwasher would not know door was closed

Parts diagram shows Striker can be popped out with screwdriver. Not true. It has a screw bolting it internally. Impossible to get to unless you disassemble the entire door. We took a power drill and small drill bit and bore it out like a cavity in a tooth. Needle nose pliers to extract the screw. Pretend your a dentist. Fixed it in 5 minutes. Replacement fit tight. A+

Parts Used:

Latch Striker

Lesa from BETHALTO, IL
Difficulty Level:
Very Difficult
Total Repair Time:
30 - 60 mins
Tools:
Pliers

1 person found this instruction helpful.

Was this instruction helpful to you?

Right part wrong description

I had to replace a docking port. Parts Select had the part, labeled as stainless, just as this survey indicates. Well folks, the part I received is 100% plastic. It it the correct part, just not stainless. Should it have been stainless due to a faulty plastic design? I don’t know.

I used Parts Select for the simple directions for installation. I was eventually linked to a YouTube video for a completely different docking port. Does my part slip on? Does it press in? I don’t know.

Needless to say, this has been a cheap but frustrating ordeal that is not yet over. Thanks for having the stainless, but really plastic, part and for having directions for some other part available.

Parts Used:

DOCKING PORT SS

Al from HILTON HEAD, SC
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours

1 person found this instruction helpful.

Was this instruction helpful to you?

Dishwasher not operating. Would fill, not operate, then drain.

Performed all checks on youtube...water coming in, course and fine filter cleaned, drain pump working (heard it come on and no water present and cycle end). Swapped water inlet valve bc it was the cheapest poss fix $19. No luck. Ordered circulation pump and motherboard. Swapped pump, very easy with machine out and turned on its back. Temp reinstall and ops checked good. Contacted Partselect for return slip, emailed immediately and sent thru post office.

Parts Used:

Water Valve & Harness Assembly

Todd from PLYMOUTH, MA
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Pliers, Wrench (Adjustable)

2 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Leaking hose

Did it myself

Parts Used:

WASH PUMP SERVICE KIT

Mike from WARREN, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

missing screw for Spray Arm

Remove top rack stops, slide out upper rack from rack railing, turn over upper rack and attach spray arm using spray arm bearing and screw. Reassemble in reverse order.

Parts Used: