AS2728GIHW Maytag Refrigerator - Instructions

Removed two screws from front cover,unpluged circuit board. Removed two more screws and cliped the door in place.

Popped out broken switch with blunt flat edged instrument. Disconnected switch from unit . Plugged new piece in and reinserted into side panel of refrigerator. Very easy.

All work was done by hand. I removed the cover plate, unscrewed the existing water filter and screwed in the new one. I returned the cover plate to its original position and bled the air out of the line by running the water dispenser for a few minutes. It could no have been easier.

Remove (slide forward) the ice dispenser drain pad from the bottom of the ice dispenser assembly on front of the freezer door. Removing two screws (star head) at the bottom allows the ice dispenser cover to be removed. Remove 3 screws holding the ice dispenser assembly to the freezer door to gain access to the flapper. Remove and replace the flapper and reverse the steps to reassmble.

removed 4 screws, reeplaced broken ice door,
replaced 4 screws. Easy job with your site diagrams.

repair&parts instalation was easy but troubleshutting difficult.

I followed the video of your repair man. Made it very easy.Thanks.

Removed by hand the old water filter and installed the new one.

I pulled the drive ring off of the icemaker and replaced it with the new part. Saved a $150 service call plus cost of part. It cost me a little over $11.00 and a repairman probably would have charged $30.

I unscrewed the support and replaced it with one that I ordered. It was fast and easy.

Took door off refrigerator and removed worn parts and replaced the aforementioned parts, which took only a few minutes.

The instructions in the package were not helpful. They wanted me to cut the wiring harness and described where to cut based on the wire colors. My wires were not the same color! I removed the light mechanism using a combination of a screwdriver, putty knife, and plain old muscle with my fingers! The wiring harness unplugged easily and the new one inserted. It was easy to push the whole assembly back into the door. I spent more time looking for something to cut the wiring harness with (and never did find it) than the whole job actually took without needing to cut anything!

I did not do the repair yet, there is no schematic on how to route the hose; also no description of how to do the routing/connections.

Removed old ejector arm and installed new part.

Removed approx. 5 phillips screws to access the flap from the outside of the freezer door and R & R'd the flap, then repaced the screws. Fairly simple installation. Most impressive was how easy it was to find the part here and the quick delivery.