All Installation Instructions for Amana Refrigerator AFB2234WEB0

broke my original Kickplate Grille

knelt down, positioned replacement kickplate; popped into place, stood up!

took longer to open the box and peel bubble wrap off item than to replace it!

Parts Used:

Refrigerator Kickplate Grille

Daniel from GEORGETOWN, TX
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Center Crisper rail

Take everything off the top self, lift the self install the new part ,put self back in place and then install the drawers again. Took minutes.

Parts Used:

Refrigerator Center Crisper Drawer Slide Rail - White

Richard from PASADENA, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Too much beer!

Caused the shelf on my fridge to break a ladder hook. I didn't even know where to begin looking for an Amana refrigerator shelf mount bracket, but luckily found this website from a Google search. The part was super easy to find, arrived in two days, and was a snap to install. What did people do before the internet?

Parts Used:

Crisper Drawer Cover Support

Sean from Bellevue, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Water not draining to pan. It caused an ice build up under the freezer draw

Remove the grate at the back of the refrigerator. Remove the existing drawn tube. Replace the exiting drain tube with the updated drain tube. Check to see if water was draining properly. Replace the grate. Sit back and have a beer.

Parts Used:

P-Trap Drain Tube Kit

Rich from WINSTED, CT
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Pliers, Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

I purchased a display model that was missing a part.

Snapped on the new toe grille.

Parts Used:

Refrigerator Kickplate Grille

Monte from Longview, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Random clicking noise

The toughest part was pulling the refrigerator from the wall....After removing the back-bottom access panel the compressor is right there with the Start-Dev and Cap..Took a few min to remove and install new parts....Very Simple and works great...no more clicking..

Parts Used:

Refrigerator Capacitor

Refrigerator Compressor Start Relay

Mark from SAN DIEGO, CA
Difficulty Level:
Very Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

I had a loose fitting old condensor fan blade on my new motor.

I made a temporary repair by drilling the old blade plastic hub and put a small screw in it to hold it on to the shaft until the new blade arrived. The new blade came in within the two days I needed before Thanksgiving. I removed the old and pushed on the new. There were 8 screws on the back guard and two to hold the motor on. It was a snap.
Thank you PartSelect.com The wife is very, very happy now, we had 51 coming over for Thanksgiving. :)

Parts Used:

Fan Blade

Roger from SMITHFIELD, RI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Glides were broken

Just swapped out new for old. Couldn’t be easier!

Parts Used:

Deli Drawer Glide- Left Side

Refrigerator Deli Drawer Glide

Jake from RICHMOND, VT
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Cracked humid drawer

Complete replacement of the plastic drawer.

Parts Used:

Refrigerator Crisper Pan

Julie from BATH, PA
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Repaced the right-side door light switch

Killed the power to the fridge. Then, used a small, thin screwdriver to depress the clip on the bottom of the switch and wriggled the old switch out. The two wires easily came off the contacts with pliers. Connected the wires to the new switch and snapped it into the hole--clip facing down and contacts facing up. Turned the power back on and checked the switch. Worked perfectly! Easy job.

Parts Used:

Refrigerator Switch

Charles from SEGUIN, TX
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

The vertical mullion rail went bad

I left this broken rail hang off my refrigerator for almost a year I finally decided to investigate the possibility of ordering the part on line. I found the part on line in minutes and when I received the part it literally took me 3 minutes to install.

Parts Used:

Refrigerator Vertical Mullion Rail - Black

Ed from OCEAN CITY, NJ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Gasket not sealing good

Opened the bottom freezer door and pulled the gasket out of the groove. Pulled it out around the door and put the new one back around the door and the pressed into the groove. There was one place that a flat spot didn't take shape so I used a blow dryer to heat it up some and now it seals perfectly.

Parts Used: