AB1924PEKB4 Amana Refrigerator - Instructions

The best part of the repair was how easy it was to find and order the part. Instead of searching the parts houses around town I just went to the PartSelect web site, quickly found and ordered the part in about five minutes, received the part the next day at my home and was ready to make the repair. Wow! What a pleasure for something to work the way it was meant to. Removed old switch located by prying out with sharp knife or screwdriver. Don't worry about breaking it or cracking plastic. Disconnect(unplug) wires from back of switch. Replace (plug-in) wires on back of new switch. Insert in location of old switch. Finisheed.

The repair was easy ... but this Part Select will be my favorite forever!! The people on the phone were awesome ... the part came immediately ... and we couldn't be happier!!!

Thank you so much!! You're the best!!!

Installed the Dairy Door on the new Dairy Tray. Removed the old tray, replaced the new tray on the refrigerator door. The vegetable and fruit drawers were removed and the glass shelf was removed. The new plastic rail was placed in the slot and the shelf replaced. The drawers were replaced.

The hardest part of this job was to select and purchase the correct parts. Your website mad that task easy.

Watched the video. Everything went great, Super simple

installed new parts

removed drsws and shelf put new center rail replaced draws done

A very cold and brittle switch in a 17 year old fridge. Used screwdrivers to pry out with some resistance Had to cut the molded plug in half and split wires, because replacement contacts were farther apart than the original. End result, works great.

I'm a pretty handy person generally but I had to call on my engineer neighbor to help. I've never soldered before so I didn't feel comfortable installing the thermistor. I had everything ready for him so all he did was cut the existing thermistor out, strip the wires on the replacement , solder and tape and he was seriously done in 10 minutes! I replaced everything and plugged the fridge in to find that my fridge still freezes everything. I have now ordered the damper control and gasket to hopefully fix this problem.

Disconnected electrical plug between ice maker and frig. Removed 3 screws holding ice maker in place and removed ice maker. Ice tray shelf only uses the upper 2 screw locations. It would have been helpful if I had been told that the original screws holding the ice maker would not work because they are too short, and that I would need some special washers/spacers that fit the new shelf. Luckily I had longer screws available and I was able to fabricate the washers from some scrap plastic. Installed successfully.

replaced electric control board, defrost for six hours. next day (24 hours) same problem, dusterhoff2928@charter.net

Pry old switch and pull out. Disconect two wires. Put two wires on new switch, must be inserted right and connections not loose. Put switch in, making shure wies do not come off and snap in place

Remove 2 screws/old handle off and new one on-simple?

After disconnecting the electricity. I followed the instructions as indicated in the "HOW TO" article on the website. I used a steel putty knife and pried the light switch out of its retaining hole. I worked the right side the most since this is the side with the retaining clip. After I removed the switch I transferred the two electrical outlets to the new switch and easily snapped it into place. Engaged the electric power and tested the switch.

Although there where no instructions, reading the comments by others made this a really easy replacement.

disconnected el. power to fridge. pried out broken switch with small screwdriner and pulled out w/water pump pliers. installed new switch and pressed into opening.