All Installation Instructions for Amana Refrigerator AB1924PEKB

Broken center crisper rail

Total time 10 minutes. 9 minutes to clear out the food and 1 minute to install the part. Installation was self evident and could have been done blindfolded. Part just snapped in.

Parts Used:

Refrigerator Center Crisper Drawer Slide Rail - White

Allan from Tucson, AZ
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Broken clips on old part

Snapped in new part

Parts Used:

Damper Cover Insert

Rose from OCOEE, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Freezer iced up

Let the ice in the freezer melt while installing P trap drain tube

Parts Used:

P-Trap Drain Tube Kit

Dale from MECHANICSBURG, PA
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Fridge was leaking water because of bad drain

Switched the drain out using the video tutorial
Fixed the problem
Have had no more drain issues

Parts Used:

P-Trap Drain Tube Kit

David from NEWTON, NJ
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Fridge warm, freeze cold.

Thermostat kit it only had one connector. Fortunately I had a small wire nut that I used on the other wires.

Parts Used:

Defrost Thermostat Kit

Donald from OMAHA, NE
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Icemaker was not making ice and was noisy

I first removed the icemaker pump and filler tube fron the back of the refrigerator by using an adjustable wrench and pliers. (very simple connection) I went ahead and replaced both items at that time.

Next I opened the bottom freezer and removed the top wire tray and ice container. I removed the bottom nut from the ice maker, pulled the electrical plug lose from the freezer connection. I then just lifted the ice maker upward and off the two screws on the side wall and out it came!

I had a little trouble with the filler tube as it came into the freezer. I had to go back and forth to the back of the refrigerator and freezer a couple of times adjusting the tube, so it woiuld clear the inside freezer wall.

This was a very minor problem. I feel like if I had followed the instructions and made sure the tube came through before attaching the icemaker it would have worked like a charm!

What I really liked, was everything was in the box for the job.

Parts Used:

Add-On Icemaker Kit

Edgar from Fredericksburg, TX
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers, Wrench (Adjustable)

4 of 7 people found this instruction helpful.

Was this instruction helpful to you?

did not have a ice maker

remove parts that were not need installed water valve , ice maker unit and hooked up water supply tested and it works fine. got the parts really quick Thank You

Parts Used:

Add-On Icemaker Kit

Ralph from Argenta, IL
Difficulty Level:
Really Easy
Total Repair Time:
More than 2 hours
Tools:
Nutdriver, Pliers, Screw drivers, Wrench set

5 of 10 people found this instruction helpful.

Was this instruction helpful to you?

The shelf split in two

Bought a new shelf

Parts Used:

Crisper Drawer Cover Frame

Lynne from ROCKVILLE CTR, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Center Crisper rail

Take everything off the top self, lift the self install the new part ,put self back in place and then install the drawers again. Took minutes.

Parts Used:

Refrigerator Center Crisper Drawer Slide Rail - White

Richard from PASADENA, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Glides were broken

Just swapped out new for old. Couldn’t be easier!

Parts Used:

Deli Drawer Glide- Left Side

Refrigerator Deli Drawer Glide

Jake from RICHMOND, VT
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

I had a loose fitting old condensor fan blade on my new motor.

I made a temporary repair by drilling the old blade plastic hub and put a small screw in it to hold it on to the shaft until the new blade arrived. The new blade came in within the two days I needed before Thanksgiving. I removed the old and pushed on the new. There were 8 screws on the back guard and two to hold the motor on. It was a snap.
Thank you PartSelect.com The wife is very, very happy now, we had 51 coming over for Thanksgiving. :)

Parts Used:

Fan Blade

Roger from SMITHFIELD, RI
Difficulty Level:
Very Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

changed the light bulb still would not work so I figured it was the switch sure enough.

I took a chance and ordered a switch that is next to the top of the door. looked for how to remove it easily done in ten minutes works fine last long time.

Parts Used:

Refrigerator Door Switch

anthony from HAVELOCK, NC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

3 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Water not draining to pan. It caused an ice build up under the freezer draw

Remove the grate at the back of the refrigerator. Remove the existing drawn tube. Replace the exiting drain tube with the updated drain tube. Check to see if water was draining properly. Replace the grate. Sit back and have a beer.

Parts Used:

P-Trap Drain Tube Kit