95-2162 Refrigerator - Instructions

George from Sunnyvale, CA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

end cap broke

First I removed the broken end caps. I placed the new end cap onto the shelf bar and snapped the end cap into the holding slot on the door interior. Took about 5 minutes. Very easy.

Parts Used:

Connie from Seneca, SC
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Defroster didn't work

Ordered a new defroster timer and replace old one. It works just fine. A $35 repair vs a $500 new appliance.
Cool.
GWE

Parts Used:

George from Eatonville, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator keeps frosting up and not cooling

Refrigerator started frosting up and running all the time.I'd defrost it and it would frost up again in about a week.The timer seems to be work so I just guest it mite be the Defrost Thermostat.I removed the duck in the center and back panel in the freezer compartment defrosted it and switched Thermostats and replaced panel and duck, going to lower compartment of the refrigerator.So far it seems to be working a little more time while tell.

Parts Used:

Defrost Thermostat

Marvin from Pima, AZ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Coils kept icing and refrigerator stopped cooling lower compartment.

Replaced defrost timer & thermostat.

Parts Used:

Defrost Thermostat

Raymond from Sierra Madre, CA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

5 of 14 people found this instruction helpful.

Was this instruction helpful to you?

Crisper cover support Bar was broken

Put glass in the new crisper cover and the support bar in place.

Parts Used:

Crisper Pan Cover

Crisper Drawer Cover Support Bar

Patricia from Eupora, MS
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Refer iced up and would not keep the bottom cool. It was 70 Farenheit inside.

I simply removed 4 screws holding the casing and then 2 more holding the timer. It was very easy. I then replaced the timer by unplugging and plugged the new one in. I replaced all the screws and the job was done. Less than 30 minutes. I was very impressed with the shipping time. When I ordered the part, I had it the next day.

Parts Used:

Larry from Newton, KS
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers, Socket set

2 of 5 people found this instruction helpful.

Was this instruction helpful to you?

The door shelf retainer bar was too long, 6" to 8"

I measured the width I needed and used a handsaw to cut it the proper length. Then I snaped the pieces in and it was a perfect fit.

Parts Used:

Door Shelf Retainer Bar - Cut to Fit

Jane from Hudson, WI
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins

1 of 2 people found this instruction helpful.

Was this instruction helpful to you?

light bilb went out

replaced it

Parts Used:

Light Bulb

Denise from Landover, MD
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Cross bar end caps were broken.

I put the end caps on the cross bar and reinstalled it in the fridge. Easy job.

Parts Used:

Charles from Fox Island, WA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

frezzer iceing over and not cooling the refrigerator

Just removed the two screws and unpluged it.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.

Parts Used:

Marcus from Pine Hill, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 4 people found this instruction helpful.

Was this instruction helpful to you?

both end caps broke

Door panel was already off. Took off broken caps, placed new ones on & put back on door.

Parts Used:

Rita from Verona, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Broken End Caps On Center Door Shelf

I removed the broken end caps by hand. They snap in to the center retainer bar. I ordered replacement parts from part select on their website. New end caps arrived in a couple of days. I installed new caps. No tools needed. Great service by part select. Thank you tm staten island ny

Parts Used: