66515662990 Kenmore Dishwasher - Instructions

watched a video

Removed plastic wing-nut. install new bushing.

Swapped out the old upper dish rack with a new one. A video made the change simple.

Removed and replaced leaking water inlet valve, 10 minutes and saved me a hundred in plumber fees.

Snap the old lid off, remove the pin & spring & install new Pin & Spring. Very easy. Thanks To Parts Select got the right parts.

Followed instructions, those were OK.
Dishwasher front still leaking

Just screwed the new cap in. This PartSelect was AWESOME. So easy. Lighting fast shipping !!!!

Took off bottom plate (2 screws) and ran unit to ensure where leak is from....it appears to be the door seal. Pulled out old seal with fingers and replaced door seal, ensuring its properly "fitted"..ran unit, no leaks, put bottom plate back on

Took less than 5 minutes. Pried edge of old door seal out with a flathead screwdriver, then slowly pulled out old seal. Thoroughly cleaned area for new seal with rubbing alcohol, inserted new seal and trimmed the end to fit just right. Presto, no leaks whatsoever!

one screw held the switch in place and is located at the front left of the machine at the bottom access panel, the new part was exactly as the old, the wires pulled off easy and plugged in to the new with no problem, switch still makes a noise and did not fix the problem, my fault not yours. Timer is moving thru the cycle but machine does no run or water flow in.

It was a very simple repair. I removed the old door seal out of the track and installed the new seal.

removed old seal, placed new seal in place. Used my fingers to push it in place. It didn't work as it still leaks. I've put vaseline on the seal and door and it helps but still leaks. The dishwasher doesn't overfill, so I still have the problem, just not as bad.

Really simple, took out bottom rack, unscrewed nut, removed sprayarm----took out old part (seal) put in new seal----put whole thing back together. Plus, you did have a "how to" video for replacing the seal, which we watched just to be sure we weren't missing anything.

Also ordered lint filter/upper agitator & agitator cap for my Roper washing machine, Old agitator would no longer stay on the lower agitator-----washing machine is 16 years old----snap agitator & cap together, & lower onto agitator.

Your pictures in your website for all parts, were spot on----no wondering if I was ordering the correct part.

Will use you again in the future---Thank you so much.

unscrewed the part and replaced it. Easy part replacement.....$4 part and $13 shipping.....that's nuts!

Sorry, probably need a spring as the door is fine. While reading other stories about how hard the spring was to get right, I assumed the spring was part of the door assembly.
I'll be calling and returnint the part.



















i'