66515625690 Kenmore Dishwasher - Instructions

one screw held the switch in place and is located at the front left of the machine at the bottom access panel, the new part was exactly as the old, the wires pulled off easy and plugged in to the new with no problem, switch still makes a noise and did not fix the problem, my fault not yours. Timer is moving thru the cycle but machine does no run or water flow in.

It was a very simple repair. I removed the old door seal out of the track and installed the new seal.

Took off bottom plate (2 screws) and ran unit to ensure where leak is from....it appears to be the door seal. Pulled out old seal with fingers and replaced door seal, ensuring its properly "fitted"..ran unit, no leaks, put bottom plate back on

Snap the old lid off, remove the pin & spring & install new Pin & Spring. Very easy. Thanks To Parts Select got the right parts.

Just screwed the new cap in. This PartSelect was AWESOME. So easy. Lighting fast shipping !!!!

removed old seal, placed new seal in place. Used my fingers to push it in place. It didn't work as it still leaks. I've put vaseline on the seal and door and it helps but still leaks. The dishwasher doesn't overfill, so I still have the problem, just not as bad.

pulled the old door seal off and pushed the new seal into place and it works great!
THANK YOU!

Really simple, took out bottom rack, unscrewed nut, removed sprayarm----took out old part (seal) put in new seal----put whole thing back together. Plus, you did have a "how to" video for replacing the seal, which we watched just to be sure we weren't missing anything.

Also ordered lint filter/upper agitator & agitator cap for my Roper washing machine, Old agitator would no longer stay on the lower agitator-----washing machine is 16 years old----snap agitator & cap together, & lower onto agitator.

Your pictures in your website for all parts, were spot on----no wondering if I was ordering the correct part.

Will use you again in the future---Thank you so much.

1-2-3 EASIEST JOB I EVER HAD to DO AND THE WIFE IS PROUD OF ME FINALLY.

THANKS , , ,Bat from WEST SENECA (Buffalo, NY)

I watched your video and replaced with new part in about 5 minutes. Video made it easy to follow.

Lowered door and put a weight on it to keep it open. with screwdriver pried out the old gasket. It was simple. looked at the end of the replacement gasket and inserted it into the track with the small hole down. Job Complete. about three minutes total time.

I opened the door and pulled the gasket from around the dishwasher. The gasket does not have any adhesive around it, so it pulled free almost immediately. The new gasket was pressed into place around the door and I was done. It couldn't have been any easier. I suspected it was the gasket when I saw pinched portions that did not return to the original shape and there were no visible cracks in the machine.

Sorry, probably need a spring as the door is fine. While reading other stories about how hard the spring was to get right, I assumed the spring was part of the door assembly.
I'll be calling and returnint the part.



















i'

unscrewed the part and replaced it. Easy part replacement.....$4 part and $13 shipping.....that's nuts!

I removed the cardboard insert, put the new front panel on and replaced the tabs. That was it!