66513633100 Kenmore Trash Compactor - Instructions

The online repair states the repair could be done in 10-15 minutes and actually took over an hour. It would have taken 10 minutes if I could have just purchased the metal flange that broke.

Followed PartsSelect instructions, the Compactor was appoximately $1000. when I purchased it. The kit was $26.14. I will forever be a customer of this company. Thank you, Brian

Many of you with the KitchenAid trash compactor now that there's a faulty Actuator part the continues to break, and most likely have replaced this several times. I was glad to see that KitchenAid finally redesigned a part hoping to solve this problem. Overall, installing the new part went well. The new part does require you to pull out your compactor from the cabinet so you have access. After removing the top and front panels, you'll replace the switch and then install the new pedal that activates the switch, needing to drill a couple holes to secure it. Other than that, it's very simple. Only advice is to read the instructions a couple times to get yourself familiar with what needs to be done...then you'll have a much easier time and feel more confident before you start.

Took out old gears replaced with new very easy with your dirictions.

To repair the o.e.m. actuator lever, Whirlpool supplies a redesigned actuator switch. It requires dis-assembly of the front panel which takes time since you must first remove the trash compactor from the cabinetry. Once the front panel is off and you've removed the old switch, installing the new switch requires drilling two holes. Do not use the recommended drill bit -use an oversize bit to match the core diameter of the new screws. The new switch works brilliantly if done right. It just takes time.

It was an updated revision part kit...and it went so smooth ....recommend that anyone looking to repair appliances utilize PartSelect....I know I will be ...Thank You

Follow the included instructions carefully (read it all through first) and this was a quick and simple fix if you are reasonably handy with a screwdriver and drill. It took me about 45 mins. You have to pull the unit out from under the countertop and then remove a series of small screws in order to get behind the front panel. Putting in the new actuator switch was a little cumbersome simply because there are other wires you have to work around but it's still very straightforward. After you reinstall the front panel, you attach a new foot activated button that presses down on the new actuator switch. You have to drill 2 small holes in the front panel sheet metal to attach this new button but a perfectly sized paper template is provided and it worked great. Last easy step is to replace the rubber door sweep so that the new button can be accessed with your toe. In effect, the compactor is now operated by pressing your toe against the new button on the lower right side below the door. It is a nice improvement over the old method of lifting up on the lever that you normally step on to open the door. Easy to install.

Same problem as described previously on this site. Pulled unit out and replaced the gear as described. Thanks for the info - would have been tough with out it.

replaced the large gear and put it back together.

Very simple, changed the gear, adjusted the drive and tested. Very straight forward.

The instructions that came with the swtich were very helpful. I would have had a more difficult time if I did not have the instructions.

The repair was a breeze, a piece of cake, a walk in the park, a day at the beach. The part arrived quickly and installation was fast and simple. A week earlier I had the misfortune of ordering these parts from another supplier. One of the parts obviously was not correct, so I called customer service. Although the operator was polite, she insisted that the part I received was the right one (even though it was 2 inches too narrow). I looked up the part at PartSelect.com and ordered it. It arrived the following day, and fit perfectly. Thanks, PartSelect.com.

I attempted to fix the problems many time because of what I thought was a high cost. Your online reviews convinced me that it was well worth the cost. The instructions were very good and anyone who can read, use a screw drive, should be able to accomplish this job. It could be intimidating, but you can do it. And you will be glad. Follow the directions and you will have no problems.

bought new gears, pulled it out and replaced the gears. wasn't very hard. I did expect a jenn-air to be better built (plastic gears really!) but for 30 bucks it is all better.

Replaced the limit switch. This did not alter the problem. Took off the On/Off/Start switch and dissasembled. I found the the Start switch was stuck in the on position. I reassembled the switch mechanism assuring that the Red "ON" indicator moldings were correctly positioned and reassembled everything. The Compactor now works properly. Need to add "Check the Start switch" to diagnosis.