66513472N413 Kenmore Dishwasher - Instructions

followed directions, a kid could have done it,

Our dishwasher's top rack would pull too far out which made it hard to stay in alignment. It had lost it's track stop. I easily ordered the part from PartSelect, and it came more quickly than I expected; I clicked it in place and it runs like new. It's wonderful to deal with a company that knows the frustration of not having your appliance in good working orfer.
Thank you.
Sue M
Masdsachusetts

Very simple to repair The front track stops just slide into place, easy. When I looked for these parts this place was the least expensive and the quickest delivery I have ever had. Quick, efficient and friendly online staffing. Thank you, Deb

Replaced wheel part. EXPZ.

Watched YouTube first of course. Pulled off the old gasket, found the center of the new gasket and started installing the gasket from the very top and all the way down the sides. I made sure it was in tightly and smooth. No more leak, should have listened to my wife sooner!

Pulled out old gasket, pressed in new starting middle top. No more leak.

Remove and replace by hand, no tools required

just replaced broken piece ,,,, very easy ,,, will use you again for parts should the need arise

The hardest part was squeezing the tab at the end of the track to pull it up and out so that the old wheel part could be slid out and the new one in. Fortunately, the track is open on the side facing the interior of the dishwasher so you can see what you're doing. Once that was done, it was simple to snap the new part into place, slide the wheel into the track, and replace the tab at the end.

Took off the old bracket with a screwdriver. Replaced with new bracket.

Ordered part; took part out of box when it arrived; took broken part off; put new part on. No tools needed.

Popped off the side stay on the rack, slid the new part on the rack and snapped it into position. Replaced the side stay on teh runner. Done!

The repair was very, very easy. The only tool I used were my fingers. Took me about 2 minutes. Would have been less but I forgot to remove the broken wheel before installing the new one so I had to repeat the process. This hardest part was removing the end piece from the rail. If you look closely there is a little tab that needs to be pushed forward to remove the end piece. Once that is done it's very easy. I'm sure I saved $100 vs calling a repair person. I actually purchased 2 replacement parts in anticipation of another one breaking.

1. Moved dishrack and tracks outward then moved just the dish rack only in. 2. Using screw driver, pushed plastic tongue on end cap at track and lifted off the end cap. Repeated procedure on second track on opposite side of dish rack. 3. With end caps removed, pull dish rack out and place on table. 4. Examine each track and remove any pieces of broken wheel mounts. 5. Install new wheel mount on opposite side of dish rack from good wheel mounts. 6. Slide dish rack back in place with all four wheel mounts inserted in the two tracks. 7. Reinstall the end caps on the tracks and the fix is done.

Took out racks. And releaseed bar. Released set screws and gentley pulled out unit to expose 5/16th nuts. Removed nuts and cleaned area. Used old gaskets as the new part did not come with the gaskets, Screwed in nuts. Reset bar and set rack on carriers.