63013953010 Kenmore Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
When I checked the drain filter to clean, I noticed the plastic supports were broken and the micro screen had collapsed.
I took out the old filter and replaced it with the filter I had ordered. Very easy and not necessary to call a repairman.
Parts Used:
-
C Loren from TWIN FALLS, ID
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
2 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
No water into dishwasher
Remove lower panel
TURN OFF POWER AT BREAKER
Remove water line
Remove the screws on bottom left of washer to remove solenoid valve
Pull out solenoid valve carefully there is a wire plugged into it, far enough to remove clamp on the hose
Remove valve far enough to disconnect wire
Order correct valve assembly
Reinstall in reverse order
TURN OFF POWER AT BREAKER
Remove water line
Remove the screws on bottom left of washer to remove solenoid valve
Pull out solenoid valve carefully there is a wire plugged into it, far enough to remove clamp on the hose
Remove valve far enough to disconnect wire
Order correct valve assembly
Reinstall in reverse order
Parts Used:
-
Samuel from PORT ORCHARD, WA
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:1- 2 hours
-
Tools:Pliers, Screw drivers, Wrench (Adjustable)
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Waste water won’t drain
-
Kenneth from WESTCHESTER, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:30 - 60 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Drain filter got old fell apart
-
Mary from HUNTINGTN STA, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Not getting water
shut off water, pull dishwasher out, took side insulation off, unhooked what was connected to the float switch and replaced the new with the old. Reconnected everything and put insulation back and wa-la , all done
Parts Used:
-
Ranaye from BECKER, MN
-
Difficulty Level:Very Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Nutdriver, Screw drivers
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Lid for the streak treatment wouldn't stay shut.
Use screwdriver to gently wedge the side of the dispenser body apart enough to pop out the old kid, then insert the new kid in it's place.
Parts Used:
-
Gary from NEW PARIS, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
1 person
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!