5KSB52BER5 KitchenAid Blender - Instructions

easier than i anticipated. i thought i would have to tear the unit down to get this part installed, but the replacement came with (even an idiot can do it)instructions, and it took all of four minutes. Mike in Albemarle,NC..

Pretty muched followed the directions, but after reading all the reviews I knew what do to before the part arrived. Super easy. My blender had been out of commission for a while...now I'm back in business. Well worth the $14 (part and shipping).

I just followed the instructions to remove the old drive coupling and screwed in the new one.

Hardest part was taking off the old coupling. I locked the drive with a thin wrench and pryed the coupling off. Took about ten minutes to get off and two minutes to put the new gear on. Remember the thread is counter clockwise. PartSelect was great the part arrived in two days.

using the screw driver I pryed up on the old coupling as out line in the instructions that came with the part. The old part cam off easily and the new one just screwed on. The replacement took only a few minutes.

I couldn't unscrew the old coupling (left hand thread) so I carefully sawed a piece off being careful (the somewhat difficult part of the job) not to damage the threads on the drive motor. Then I used pliers to remove the rest of the drive coupling. Then it's just a matter of screwing on the new coupling. Good as new and I didn't have to buy a new $150 blender.

Forget about the repair blogs. The coupling includes a repair instruction sheet. It actually took longer to read the sheet than it did to do the repair. Follow the repair sheet instructions. Very easy, however not intuitive.

After I discovered that it needed to be screwed on turning to the left it was simple.

Pried the old coupling off and unscrewed the metal piece remaining then screwed the new coupling on.

Following the instructions which was quite clear.

The repair is easy. Just follow the directions that come with the replacement part. And parts select is awesome. I received the parts within a couple of days and fixed it right away.

I will definitely use this company again. The blender was over $120 when I brought it and I did not want to spend that kind of money again. My cost to fix was about $8.00 for the part and $7.00 for shipping. Hmmmm, $15 vs. $120+ sounds like a good deal to me.
Thank you.

My husband lifted off the old piece with some difficulty and then just screwed it back on. We were really glad to have our blended back as good as new for under 20$!

I inserted a metal rod in the bottom of the base while I held it sideways to keep the motor from turning and I used pliers to twist the coupling off counterclockwise.
I thought at first I was doing it wrong because it wouldn't nudge so I left it alone. I then read the repair stories again and went back to it and it right came off. I guess there was a lot of gunk holding it tight.
Of course when the new one came days later it was easy to twist it on. Thank you for all of your stories. They were very informative and encouraging. Without them I'm not sure if I would have attempted it myself.

simply hold the axel with the wire stripper to prevent from rotating. Using the pliers firmly turn old coupling counterclockwise until loose. Once this coupling is totally off you are ready to screw on the new one. Very simple. The most difficult part was finding a tool slim enough to fit between old coupling and base to hold axel from spinning. I ordered part on sunday and received it on tuesday. It spared me from throwing away a $120.00 dollar kitchenaide blender.

Read prior reviews from people who have done the same repair. Grasped shaft with thin nosed pliers and turned drive coupling counter clockwise.

.