5KSB52ATG4 KitchenAid Blender - Instructions

This was quite simple and easy to replace.

Just follow directions included with part, very simple and understandable. GOOD BUSINESS, THANK YOU

Per directions, I pried the drive off the screw. I was surprised that the drive came off the screw by just a prying action, but that's how it's done. The metal base to the drive is softer than the screw so there was no stripping of the screw threads. Then I just threaded the new drive onto the screw and done.

The longest time spent was in getting the part out of the package and reading the directions. All told it took less than 5 minutes.

The rubber part of the drive appears to be very brittle as it chipped off the drive gears. But it was easy to repair and they do last about 5 years.

A 5/16" thin wrench fits the shaft beneath the coupling. The shaft has a flat side on it. The coupling comes of easily turning clock-wise for the reverse threads..

I tried turning defective coupler off after inserting a narrow screw driver into the motor fan bladed. That did not work. I then used a wide bladed flat-head screw driver to pry the defective coupler disc off the motor shaft. After prying each side over and over, the old coupler base broke free. I cleaned the remnants of the base from the threaded shaft and then screwed the new coupler on only finger tight. It went on easily. For less than $15.00 (including shipping) we now have a working blender that hopefully will last another 10 years.

pry rubber up enough for vice grips, unscrew coupling,left hand threads,screw on new. Came with instructions, in English.

I watched the video on the website and I realized I could repair a $100.00 blender myself, for under $20.00! So, so easy and the part came in two days. Great company, Thanks!

I followed the included instructions.

Removal of the old coupling was easily done by gently prying it up. The threads on ot are much softer that the shaft.

Screwed the new coupling on and done.

I also bought two of these couplings as the rubber on it WILL break off again.

To start with the coupling, I followed the directions by using a flat screwdriver and a thick towel. I placed the towel under the screwdriver to protect the base unit from damage as I pivoted 1/2 of the tip under the coupling, pulling it up as I went around until the coupling popped off. Then I cleaned the remainder of any metal left behind. Then I attempted to screw the coupling on clockwise but the screw opening was slightly to small. So I plugged in the unit and held the coupling with the screwdriver in place and turn the unit on stir and it screwed it on clockwise.
Next, the seal was replaced at the bottom of the jar. And I was finished. Easy as pie.

Pried the old coupling off and unscrewed the metal piece remaining then screwed the new coupling on.

it was too easy, i only used my hand to screw the coupling to the blender.

Using the precise instructions provided by parts select, I used a big screw driver and pried off the old coupler and cleaned the area and screwed on the new coupler. Fixed!

The part finally arrived 3 weeks later, after being out of stock and back ordered a couple times.

The coupling split apart on my Kitchenaid Blender. I ordered the coupling part and "Bingo", I was back in business. It took no time at all and one screwdriver. I saved penty of money by not having to buy a new appliance.

It was very easy to unscrew the coupler I used locktight to put on the new part. Thank you sending
the right part the first time
Albert

Released cup drive with screw driver and un-screwed, screwed on new driver.
That is all, works like a new blender.