All Installation Instructions for Kenmore Refrigerator 59677532700

crisper drawer center rail broke

Really easy once I figured out which way the rail went in.

I used the repair as an excuse to clean the refrigerator!!

Parts Used:

Refrigerator Center Rail

Refrigerator Crisper Frame Support

Diane from Glendale, AZ
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins

5 of 11 people found this instruction helpful.

Was this instruction helpful to you?

Plastic hinge pin broken on original endcap

Really easy - Remove drawers, remove glass shelf and associated support rails, remove drawer slide from old endcap, remove old endcap, reverse proceedure installing new endcap - now the hard part, have a cool softdrink while you carry the old endcap and packing material from the new one out to the trash.

By the way - the part got here really fast - thanks for the great service.

Parts Used:

Pantry End Cap Kit, LH and RH

ROBERT from Lufkin, TX
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins
Tools:
Nutdriver, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

broken end cap

took out the drawers and glass shelf and unscrewed the sides took parts for drawer glide off put them on the new part reinstallled saved $110 service cll and $20 on the part!

Parts Used:

Pantry End Cap Kit, LH and RH

chris from las vegas, NV
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

3 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Cracked lid, broken hinge - right side

Two phillips head screws out to remove drawer slide. Three screws to remove right side drawer support. New support placed, new lid snapped into place. The right side has an adjustment lever. Re-routing that took the longest. The arm had to be removed and twisted to get the adjustment knob off and on.

Parts Used:

Refrigerator Pantry Drawer Door Cover

David from Plattsburgh, NY
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Door on the pullout lower "Pantry" had cracked

Part was pretty ubiquitous so plastic door pins part fits a lot of refrigs, no tools necessary, new part is flexible enough to bend slightly to fit over pins at side. Mine was a bottom freezer type.

Parts Used:

Refrigerator Pantry Drawer Door Cover

Donald from RICHMOND, IN
Difficulty Level:
Really Easy
Total Repair Time:
30 - 60 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Bad Compressor Start Device and Capacitor

Followed Youtube video from Free Repair Help. Only problem was getting down low enough to see the pins on the Compressor to plug the replacement Compressor Start Device and Capacitor-could not replace the old clip to hold the unit to the Compressor like the old unit had. At 77 I just have a problem bending over.

Parts Used:

Compressor Start Device and Capacitor

JOHN from LOVELAND, OH
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Socket set

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Parts broken or missing

followed instructions and used common sense and the salesman was very helpful and knowledgeable and he contributed a lot of help in finding the right parts that fit

Parts Used:

Pantry Drawer Divider.

Refrigerator Crisper Frame Support

Pantry End Cap Kit, LH and RH

Carlton N from VALDOSTA, GA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Too much weight on shelf over time caused it to crack down middle

Removing the old pieces & figuring out how to separate the front trim so it could be reinstalled on the new frame took the longest! (released the securing tabs with a screw driver). Reinstalling the new parts were straight forward, "no problem". (epg)

Parts Used:

Refrigerator Center Rail

Refrigerator Crisper Frame

EMILE from RACELAND, LA
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

gasket had ripped over the years where they flexed when dooors were opened and closed.

last time i tried it right away after removing from shipping box.. relaxing with with hot air gun... was not to easy... this time i allowed gaskets to relax for a week on a flat surface. in a warm room.... took less than 5 minutes per door.... no hot air needed.... VERY easy.

Parts Used:

Refrigerator Door Gasket - Right (White)

Alan from EASTON, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Cimpressor would not start

Checked compressor with amp meter, and found it was not running, found Overload Switch bad.
When removing old switch watch carefully which lug you move wires from, so you will know which
lug to put the new switch on.

BE SURE YOU KNOW SOMETHING ABOUT
ELECTRICITY!!

Parts Used:

Compressor Relay and Overload Kit

Oliver from Madison, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver, Screw drivers

5 of 11 people found this instruction helpful.

Was this instruction helpful to you?

Broken plastic hinge holding bottom drawer lid.

Took the food out. A couple of screw removals. Put drawer lid on and then put the screws in. Nothing to it.

Parts Used:

Pantry End Cap Kit, LH and RH

Bob from Blair, NE
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Nutdriver

2 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Refrigerator was missing grille

This grille just snapped into place without the use of tools. Couldn't have been easier. And the delivery was super fast; I ordered online one day and the item arrived the very next day.

Parts Used:

Refrigerator Kickplate Grille (Black)

Angela from Topeka, KS
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Hinge on 'goumet lid' in front broke off

Wasn't a big deal. Removed the the shelves and glass immediately above the endcap as well as the large 'goumet' draw. Used a nutdriver to remove two screws. Popped off the old endcap and did everything in reverse. Replaced the long clear goumet draw cover that was still intact. Thanks for making it easy!!!!

Parts Used:

Pantry End Cap Kit, LH and RH