59669984000 Kenmore Refrigerator - Instructions

Pull out the drawers and removed the old rail, place new rail in and return drawers. Like New and took about 3 minutes.

removed the shelf inserted the new rail, replace the shelf and the crisper bins.

Easy as pie: removed the baskets; lifted the shelf; placed new rail; replaced shelf & baskets.

Snapped old one off, snapped new one on

Removed the glass shelf, position the rail in its slots and replaced the glass shelves.

Removed both crispers and shelf . Inserted new rail as explained in video. Replaced everything.

Followed easy instruction video. It was like new in fifteen minutes.

Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discoloring refer handles. Thank you

Thanks for the control board. However, it arrived in two days not overnight, UPS noted on their tracking site the error was their own. Also, the part did not come with installation instructions or programming instructions. Found on youtube a video that described in detail the programming procedure: . . . . . very helpful.

Thanks,
Marc

Refrigerator completely quit due to suspected power surge as a result of daily afternoon thunderstorms. Quit means compressor would not run, LED temperature controls would not light, but fan continued working. First, replaced Start Relay & Capacitor located attached to compressor. This was successful and compressor immediately started. However, Refrigerator controls at Electronic Control Board (ECB)failed to light up indicating no control over over unit. Replaced ECB and unit lit up and control established. The Start Relay & Capacitor are slightly difficult to find as they are black in color and merge into the base of the compressor. It helps to be flexible to remove and replace this unit due to it's difficult location. The ECB is easy to access as it is top inside front behind lights of unit. Plastic housing simply unsnaps for easy removal. Instructions do not tell you to make sure that you re-install the upper narrower control board with press pins toward outside of control face. A simple item but easily overlooked as one has to "pull" at the connecting cable of the two control boards. Success finally after three days. Parts Select was great and item shipped quickly. As a contractor, one can usually figure cost of job at three times the cost of the part. This repair would have approached $600. Cost of parts was $200. Savings were substantial and would recommend DIY provided you have time.

Removed top glass and inserted the rail

Watched the video, did exactly as shown. If an 81yr old female can do it, who needs a handyman !! Thanks for the speedy delivery and for making it so easy for me to understand ! molly

Temp in fridge stayed around 45-46 degrees even at lowest setting. First went with most probable problem of replacing the Evaporator Motor Kit in lower freezer compartment, no change, next ordered thermistor in fridge area, no change, temp stayed in same range, then tried the Electronic Control Board in top of fridge, fridge works like a charm now. Very easy repair, just follow directions to progam new board. Possible cause a lightning strike near house that fried a TV about 2 years ago - fridge began to freeze items at first and went downhill from there.

Lift the glass shelf up, slip center rail in place, lower shelf. Time 1 minute.It takes more time to remove everything on the shelf than to replace the part.

I followed the video instructions and had no problems changing the part.