59665333602 Kenmore Refrigerator - Instructions

The repair was very simple, just put the parts in place. We were very please with the quick shipment and the good prices.

remove two crispers and glass top . Replace rail.
Note
This is 3rd time this part in about 5 years has needed replcement. If there is a next time I would expect a "freebe". Service is great and replacement rail came in jig time.

I noticed the coils very dusty dirty, tried brushing it clean, ended up blowing it clean. I noticed the condenser fan motor was never turning, I had power, so I ordered a new one. I actual received the evaporator motor, so I had to order the correct one. After changing it, and it started blowing right away. But my refrigerator is still warm. I do not know where the evaporator blower motor is located. I cannot make out from the diagram breakdown. HELP

made a call and I was taken care of immediately

We had to take a few parts from our broken piece to attach to the crisper. It would have been easier if there were some sort of instructions to get the pieces off. We were finally able to get the metal rod off and attach to the new piece. It was rather easy,

Watched the video. Everything went great, Super simple

Used UTube directions the ones that came w/part we're too generic

removed drsws and shelf put new center rail replaced draws done

The entire process took lees than 5 minutes. I simply removed the broken rail, and inserted the new one. Voila! Like new!

Pull out the drawers and removed the old rail, place new rail in and return drawers. Like New and took about 3 minutes.

The rail had broken off, so there was nothing to remove, except the crisper drawers. I had called an amana repair service and the repairman told the part was about $9 and the cost to install was $127. When I almost fainted, he told me I could probably do it myself. Wow, was he right! I ordered the part, it came in about 2 days, I looked at the rail, removed the glass shelf, hooked the rail into the little opening at the back, and bang! All done. It took me 10 seconds!!

As I was holding the part up, I didn't know it was a separate piece from the frame. The reason that initially it didn't come apart is because a sticky substance had sealed it. Once the water started, the sticky stuff melted and the glass broke into a million little pieces.

removed the glass covering the rail, removed the rail and replaced with new rail

Took out drawers and glass shelf, installed new part. Perfect fit. Easy as pie.

I placed the back of the bracket into the slot in the rear of the refrigerator and stretched the front plastic rim on the glass shelf over the front of the new center rail until it snapped into place (all the while hoping I didn't cause further damage to my refridgerator!) and wa-la, piece of cake! My impatience paid off this time!