All Installation Instructions for Kenmore Dishwasher 58714013415B

Rusted Lower Dishwasher Rack

Just slid the new rack in place. Your service in locating the proper rack was excelent. I had a very bad experience with "appliance zone" prior to contacting your company so I was very happy with your great service. Thank you

Parts Used:

Lower Dishrack Assembly

Nancy from Ft. Lauderdale, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

5 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher was leaking

I read the instructions that others had posted and completed the repair in less than 5 minutes!

Parts Used:

Heating Element Brass Nut

Alina from Orange, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

5 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher was leaking out of door seal. Sent PartSelect the brand and model number of the dishwasher and they did the rest. The replacement part was exactly the same as the old part. Delivery was fast and efficient. Only took a few minutes to replace and the dishwasher is back in running condition

Pulled old gasket off with small hook. Replaced new gasket by pressing in with my fingers.

Parts Used:

Dishwasher Tub Gasket - Gray

Everett from Bridgeton, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Changed out upper rack

Replaced upper wash blade and used screwdriver to pop off rail stops to slide rack all the way out to exchange

Parts Used:

Upper Rack Assembly (Grey)

Ron from OAKLEY, CA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

4 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Noisy, vibrating pump

After moving the dishwasher out from the cabinetry, I removed the screws holding the pump in place. Pulling the pump from the formed plastic opening, I found a toothpick lodged in the pump housing. At the same time I noticed that the front o-ring was deformed due to being the incorrect size (too large). It was installed at the factory this way.

I went online to search for new parts. PartSelect was the second or third listing on the search page. I submitted the dishwasher model number and was taken to a set of parts illustrations. I was easily able to find the o-rings I needed.

Parts Used:

O-Ring - Front

O-Ring - Rear

Marshall from Beaverton, OR
Difficulty Level:
Easy
Total Repair Time:
1- 2 hours
Tools:
Screw drivers, Wrench (Adjustable)

5 of 8 people found this instruction helpful.

Was this instruction helpful to you?

Water inlet tube had worn a hole in it

Removed old hose and went to install new hose from Part Select. Part received was not the same as advertised. It was 6-8 inches shorter than the original hose. Would not make the necessary turns because of shorter length. I even went to Video instruction on installation even though I have been in Machine repair for 30 years , this video showed using the shorter hose and when installed in the video hose also had a kink because of hose length. Had to stop repair and go to hardware store and purchase a longer hose. This purchased hose from the hardware was 50% cheaper and actually worked. I also paid for 2-3 day shipping and received part 7 days later. I am very disappointed with Parts Select and am an owner of an Equipment Rental Facility and will never utilize Parts Select again.

Parts Used:

Dishwasher Water Inlet Tubing

Michael from MARSHALL, MI
Difficulty Level:
Very Difficult
Total Repair Time:
More than 2 hours
Tools:
Pliers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

leaked at the bottom of door.

My brother in law installed it for me. There was some difficulty finding the right angle but once we realized we needed to start at the very right side it went well. So far no more leaks.

Parts Used:

Dishwasher Door Bottom Seal

Lynda L from BRIGHTON, MI
Difficulty Level:
A Bit Difficult
Total Repair Time:
30 - 60 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Wouldn't drain

Pulled the dishwasher out, rolled it onto its right side, removed the old pump by removing the 2 electeical connectors and 3 #20 torque screws, and replaced the pump. The most annoying thing was it dumping water on the floor. The rest was relatively easy.

Parts Used:

Drain Pump -120V 60Hz

Erinn from FINKSBURG, MD
Difficulty Level:
Easy
Total Repair Time:
30 - 60 mins
Tools:
Screw drivers, Wrench (Adjustable)

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Bottom door seal leaking on my dishwasher

Still have a slight leak, but I'm thinking it may just need time to seat itself.

Parts Used:

Dishwasher Door Bottom Seal

Alex from COMMERCE, GA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

wheels break or bend or fall off

if the wire they snap on was bent it needs to be straightend.......they just snap on. easy to install but wish they had better wheels so this problem would be solved. My 2 sons have same brand dishwashers and have same problem.

Parts Used:

Wheel & Bushing Assembly

ALBERTA from FAIRBANKS, AK
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

The door springs were broken and the dorr was very heavy to open and close.

I removed the two screws and then moved the dishwasher out a little bit (about 6 inches). I pushed the dishwasher toward one side to make room for me to change the spring with my hand and repeated the same procedure for the other side. After the spring change, I turned an old dishwasher to a new one.

Parts Used:

Door Spring

Yangde from Raritan, NJ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Bottom seal on door came out and melted on heating element.

Took me about 2 minutes to repair, no tools to repair, very easy installation repair!

Parts Used:

Dishwasher Door Bottom Seal

Danny from Collierville, TN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

3 of 3 people found this instruction helpful.

Was this instruction helpful to you?

Dish washer leaking at the door

Pulled off the old gasket and replaced it the same way with the new one.

Parts Used:

Dishwasher Tub Gasket - Gray

Brian from Milford, MA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

4 of 6 people found this instruction helpful.

Was this instruction helpful to you?

Dishwasher door strike piece broke. Door had to be propped closed each time dishwasher was used.

Took out the two retaining screws and pulled the unit forward. Took the old door strike out and put in the new one. This site is where I go for all my appliance repair parts!!!

Parts Used: