4200NH Makita Circular Saw - Parts

Flat Washer 6 This is an authentic Makita replacement part that has been sourced from the original manufacturer to be used with circular saws, table saws, masonry saws, planers, demolition hammers, and angle cutter... Add to cart

Edge Guide This item has been sourced from the original manufacturer to be used with circular saws from Makita. The metal edge guide attaches to the saws foot or base assembly. The guide is used to measure the d... Add to cart

Retaining Ring S-8 The retaining ring fits next to the helical gear. This is a genuine Makita part sourced directly from the manufacturer for use in saws. This part is priced individually and is made of metal. A screwdr... Add to cart

Spring Washer 6 This part is available individually. The spring washer fits between the wing nut and the flat washer. This washer is small and will need to be replaced if it gets lost or if it breaks. It is made out ... Add to cart

Inner Flange 36 Add to cart

Motor Housing Includes 2 Each 643708-9 BRUSH HOLDER 5-11 Replaces Part Number: 150863-5

Needle Bearing 810

Screw M5X10

Armature 115V

Field 115V

Cord Set This cord is a genuine Makita replacement part and is sold individually. This cord is made for the double insulated tools shown below It is a two wire cord with two prongs and does not need a ground wire.

Tension Spring 4 This is an authentic Makita replacement part manufactured for use with circular saws. The tension spring is used to allow the lower cover to be pulled back after it pivots when the blade passes throug...