3822PRA Magic Chef Range - Instructions

placed knob on clock shaft with my fingers

removed drawer from track replaced supports on track and one on the drawer.

I unplugged the stove. Took out the burner and removed receptacle by pulling it out of the bracket and clipping the wires. One thing you want to make sure is that when you clip the wires from the receptacle you're replacing you leave enough wire so that you can connect them to the wires on the new receptacle when it is in place on the stove. I had just enough but would have liked more. The bracket I received didn't match the one on the stove so I used the one on the stove since the receptacle itself was the same as the one I was replacing.

First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires reverse the order to install the socet was easy but after i was done discovered that the base of the old bulb was stuck in the socet keeped it for future use

First I disconnect the breaker. I removed the defected receptacle and cut the wires. I connected the new receptacle with parts with the new part. Turned the breaker back on and everthing worked fine.

Once I saw the spring clips on the new door seal, it was easy to understadn how to remove the old seal and install the new one. Looks nice !

The hardest part was taking out original light bulb because screws on shield where hard to unscrew after all this years . The old bulb vent out leaving neck in socket. It took narrow electrical pliers to get neck out .The generic appliance bulb did not fit and had aluminum neck ,not recommended for brass sockets in ovens.Putting new light bulb in was not the problem.

the new elements were super easy to replace. the old ones just pulled out and the new ones easily pushed in. the top one was a little more difficult only because it had brackets that had to be slid of and then slid onto the new one.

The repair was just a matter of sliding the old one out and plugging the new one in. The ease of use of this website was wonderful. Super fast shipment. Im very pleased.

It was very easy to fix

My husband unscrewed the old element and pulled out the wires and took the old element off and reconnected the new element and screwed it back in in less than five mins. Your video explained how to do it. The service was great. The price was good and it got here fast. I ordered it on Sunday and it was here by Wed.morning.

unscrewed the element and pulled it out, then put the new element in.

We repalced the heating element n no time. Easy to do and the price couldn't be beat!

Removed two screws that attach bake element to rear of oven. Slid off blade type connectors at each end. Slid connectors onto new element. Pushed element into place and reinstalled two screws. Tested. Perfect. Took longer to do this survey than to do the repair! The one day shipping service was a big plus.

unscrew 2 screws, pull 2 connectors off, put in new part in reverse order - easy fix.