All Installation Instructions for Kenmore Refrigerator 363868

Noisy fan

Emptied freezes, turned off power, took floor of freezer out [4 screws ], took two screws out of fan mounts and replaces fan. Reassembled by reverse process. Simple

Parts Used:

Evaporator Fan Blade Kit

Robert L. from Eldred, PA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

Was this instruction helpful to you?

light switch quit working

removed the inside fridge electrical panel and swapped switches

Parts Used:

LIGHT SWITCH

David from Simpsonville, SC
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

Was this instruction helpful to you?

sticky switch

easy pry out, disconnect wiring, connect on new switch and press in switch.

Parts Used:

LIGHT SWITCH

ANTHONY from NEW EGYPT, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

light would not stay on

First I flipped breaker to off position for refigerator, Pulled down on socket and broke it free. Then took needle nose piars to pull wire and plug out from hole, so I could conect to new light socket then snaped it in place . Hardest part was getting wire and plug out of hole.

Parts Used:

Light Socket

Kenneth from Leavenworth, KS
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

needed new light socket

Pulled out old socket.pushed in new one.

Parts Used:

Light Socket

Charles from Williamsburg, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

failed light switch

I started removing the switch by prying on the right side with a screwdriver, when it emerged enough I used pliers to finish removing it. I then unpluged rhe wires from the bad switch and pluged them on the new switch and "poped" it into the hole.

Parts Used:

LIGHT SWITCH

Jules from Crowley, LA
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

no light in freezer

Connected the 2 wires and pushed in the switch until it clicked.

Parts Used:

LIGHT SWITCH

christopher from collegeville, PA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

Was this instruction helpful to you?

switch wouldn't come out anymore and turn light on

Gently pry out switch in door jam with screwdriver and pull both connectors off and put connectors on new switch then push switch back into the hole. Looked it up on the internet and video showed how to and also had link to new part, ordered and less than a week later the fridge is bright again. I have an older freezer also and it seems that they all use the same switches. Very Very easy

Parts Used:

LIGHT SWITCH