25372112014 Kenmore Refrigerator - Instructions

Just slid it down into place.

Placed the new glass pan cover. No issues. The part was in original condition and fit perfectly. Thank you!

Opened the box and slipped the new shelf over the existing brackets.Took approximately 1 minute. The shipping was very fast. Very happy with purchase.

Lifted old shelf out and snapped new shelf in. Took less than one minute to install. Identifying and ordering the correct part online was extremely easy due to the excellent presentation of the refrigerator and its parts. Ordered online one day and received the part the next day!

I just put the new one in with no problem

Replaced bin

LOOSENED THE TWO SMALL SCREWS THAT HOLD THE ICE MAKER UP INSIDE THE FREEZER. DISCONNECTED THE WIRING HARNESS. TOOK THE OLD ICE MAKER OUT AND JUST INSTALLED THE NEW ONE IN REVERSE ORDER. LATER THAT DAY I HAD FRESH ICE FOR THE FIRST TIME IN WEEKS!

new drawer was received within 2 days and was extremely simple to install.

The evaporator coil is behind the freezer. Remove the rack that makes the shelf and remove two 1/4” hex head screws I the back of the freezer to access the coil.
I used a hair dryer to melt the ice off the coil.
The thermostat clips on the refrigeration pipe to the coil. Remove the old thermostat and cut the wires at least a few inches from the thermostat. Clip the new thermostat on the pipe and strip about a 1/4” of the wire ends. The electrical connectors (provided with the new part) must be crimped to connect the wires.

Pulled unit away from wall and shut off water and unplugged unit. Installed water valve and reassembled, plugged back in and turned on water and checked for leaks. All good. However there is no water getting into the ice maker. The unit itself is going thru a cycle of attempting to make ice and the bail is moving and you can hear the solenoid activate but no water. I have tried to blow thru the tube going to the maker but it seems to be plugged by something. I do not know if there is another valve up there or how to clean it out. Any help would be greatly appreciated.

was very easy. just ordered a new ice maker which was delivered in a few days. The installation was so simple. Just plugged the new ice maker in and hung the unit on the 2 screws. And then tightened the screws with a 1/4 in nut driver.

replaced it

I purchased the door bins on partselect.com and received them in time mentioned. The reason why I had to order them will "melt" your funny bone. Yes, it says right on the bottom of the bin to hand wash them. Being a bachelor, I put them in the dishwasher on the bottom rack. When it came time to take them out, WOWOWOWOWOWOW, they were melted beyond usage. SO, I had to order new ones. Yea, Really funny, I know.

New door shelf bin attacched to refrigerator door brackets

I opened the box, looked at the part, and inserted it in the door in the appropriate place. That's it! Easy, fast, and exactly the the right part. No Problem.