25362922012 Kenmore Refrigerator - Instructions

All you do is snap it on

Installation was fairly straight forward. The major complaint is that the problem returned 2 weeks later. I don’t know if I care to re-invest in another switch.
Now what?

I tested the components in the refrigerator defrost function. I used digital multimeter and checked for continuity. Defrost thermostat must 32 degrees or lower.

This was not technical at all. The old door fell out and the replacement door snapped right into position. It was simple.

Ordered and replaced

This was so easy it took longer to open the door than it did to install the rack. WOW. Nice to see something fits without messing with it. Thanks.

Super easy it took no more than 5 minutes to replace the fridge door racks. Starting from opening the box when it arrived to closing the fridge door with the new racks in place. no tools needed, except a knife to open the box.

had it done in 5 seconds!!

replaced it

This was the easiest thing to repair in my house! All I needed to do was to snap the appropriate new shelf in the place where the prior piece was and we were back in business. A caveat to anyone else who might try it-get your Mfgr/model number straight as well as measure the length of the shelf to be replaced. Since my brand was not listed in the pull-down menu for replacements, the first time I ordered the shelf replacement piece, I ordered the shelf that looked exactly like the one I was replacing however the replacement was a few inches too small! Thank you PartsSelect for an easy return policy and your guidance when I called

It simply snapped into place. No tools required. A very simple repair.

The evaporator coil is behind the freezer. Remove the rack that makes the shelf and remove two 1/4” hex head screws I the back of the freezer to access the coil.
I used a hair dryer to melt the ice off the coil.
The thermostat clips on the refrigeration pipe to the coil. Remove the old thermostat and cut the wires at least a few inches from the thermostat. Clip the new thermostat on the pipe and strip about a 1/4” of the wire ends. The electrical connectors (provided with the new part) must be crimped to connect the wires.

Open the door and slide on the part. No Tools required

the repair was simple but the real story was the easy to read blow up diagram of the refridgerator after I entered the model no. Everything was numbered and I new exactly what I was ordering.
I will definatley buy here again.

I hesitate to say anything since I did exactly what their video told me to do, and it fixed the problem. Couldn't be happier. Was positive I was looking at 1000$ for a new fridge. Love being able to fix it by installing 15$ part myself. Thanks guys.