25344823600 Kenmore Refrigerator - Instructions

I unscrewed the screws that held the old fan on, disconnected the wiring harness and removed the old fan. I pulled the blades off the motor and put it on the new fan. One thing of note, the screw holes on the new fan weren't threaded. I assume this is by design, so I used the screws to thread the holes before installing it in the freezer. Once I did this, the rest of the installation was easy, just screw it back in and connect the wiring harness.

Unplugged freezer from electrical socket. Removed lower trays from freezer. Removed sound proof stripping from sides of back panel. Removed upper, lower and side screws from back, lower panel using No. 2 phillips screwdriver. Disconnected motor wires from quick disconnect power supply. Removed motor bracket from freezer back using nut driver. Removed motor from bracket using same nut driver. Replaced motor and screws in bracket. reattached quick disconnect. Attached fan blade to motor making certain to push blade on shaft securely. Replaced bracket to freezer back. Replaced back cover. Replaced stripping. Plugged into power supply. Total time 15-20 minutes.

pulled out freezer, went to floor,reached in next to compressor pulled off clip just like on the video.Pulled off old capacitator took off wire leads.Installed new one. Freezer runs great.Loaded it up with beef pork and venison. No problems.

Push the button on the right side of the ice maker filter compartment which releases the old filter. Just pull old filter out and slide the new filter all the way in. Be sure and mark on the new filter the date that will be time to change the filter again. I ordered the filter on one day and received the filter in the mail the next day and I had not paid extra for overnight shipping.

Used needle nose pleirs to slide the old fan off.Then slide the new fan on the spindle.The video really made this easy!

This repair on this model is super easy because the shroud for the fan is not really attached except for the bottom so I was able to gently bend it to give em enough space to pull the broken fan off and put the new one on.

Just like the instructions said. It took less than 30 seconds. Very happy I could do this myself. Thank you PartSelect.

unplugged the old one and pushes in the new one DONE IN LESS THAN 6 Min.

I replaced the defrost timer,defrost thermostat,and run cap.as it turned out the compressor went bad. I dont know the model because but the time I got this review I replaced the refer with a knew one . two weeks living out of coolers was so much fun !!!!!!!!

Slid the new one in easy !

take out the old....put in the new...couldn't be easier!

Replaced the water filter ( two minutes). Water not only pours evenly, but tastes great, I was so worried about finding the correct filter for the fridge. It took minutes to order online and the correct part for my model arrived. Extremely happy with my purchase.

I ordered the filter from Parts Select on 9/2/13 and it was delivered to my house on 9/5/13. You can't beat that for quick service. So then I open door to refrigrator and push the button on the lower right of the filter compartment, which is at eye level. Remove old filter. Take the caps off the terminals of the new filter and insert into compartment where the old filter was. Write the date of the filter change on the label that comes with the filter and affix to the new filter face. The filter should last six months.

Popped the old water filter out and popped the new one in, just as easy as that!!

Had my 3 year old remove the 4 screws to holds the carboard in place. Pryde the old fan blade off with a screwdriver. slid the new fan blade on to the shaft then my 3 year old put the screws back in.