25344123801 Kenmore Refrigerator - Instructions

I took out the old filter and put in the new filter. I ran some water through it and it was done.

Removed the water filter cover and then removed the water filter in place, and replaced with the new filter, replaced the cover. Repair done, less than 2 minutes.

The filter was readily removed by pressing the appropriate button. The replacement fiter easily slipped into place.

I had no problems. Screws arrived sooner than expected. It was a very simple installation. Very pleased with both the product and service.

No problem. Just push the button and pop out the old filter, pop in the new one, and reset the indicator by pressing and holding the "filter reset" button on the control panel.

I also needed to replace the water actuator handle on the front panel ice and water dispenser panel. That took a few more minutes to do but I wanted to share that I ordered the actuator arm from the Sears parts store at the same time that I ordered the filter from Parts Select. (parts select showed it out of stock and Sears showed it in stock).

I got notification that they were going to ship my part from Sears on the same day that the part from Parts Select arrived at my doorstep. It took about a week and a half more time to get the part from Sears and they charge more money on top of that.

Parts Select is my new parts store.

Loved the website. Easily found the part I needed. Filter received in two business days. Wow, really fast service. Replacing water filter was a piece of cake. Pulled out old filter, removed caps from new one and slid it into place. Will certainly look to this company for parts in the future.

just pushed into the ice filter slot

I had to tap the screw holes with a 8/32 tap so that the screws would not bind.

Removed old filter and installed new filter.

replaced water filter per instruction manual.

Part come in without delay - perfect fit - easy to install - works great

unplugged the old one and pushes in the new one DONE IN LESS THAN 6 Min.

Pulled the old filter out and pushed the new filter in.

Turned off the refrigerator, removed the bottom drawer from refrigerator, then removed the glider bars for the drawer on the left side where the filter chamber is. Removed the filter and then removed the plastic peace guarding the filter chamber. Once that was all removed we removed the screws holding the filter base in place. Now that everything was exposed we removed the inlet and outlet lines from the filter base by pushing in the nobs inside the base and pulling the lines out with some slight elbow grease. After that we just proceeded in reverse. We plugged the filter in after the base was secure to make sure that the fix worked. The repair worked like a charm, was relatively simple and now our fridge is all better with water and ice without a large repair bill :o)

I unscrewed the screws that held the old fan on, disconnected the wiring harness and removed the old fan. I pulled the blades off the motor and put it on the new fan. One thing of note, the screw holes on the new fan weren't threaded. I assume this is by design, so I used the screws to thread the holes before installing it in the freezer. Once I did this, the rest of the installation was easy, just screw it back in and connect the wiring harness.