All Installation Instructions for Kenmore Refrigerator 25336801892

door shelf ends broken off from constant pulling on door and slaming it with 2 gallons of milk in door.

Inserted the caps into the bar and snapped in door. That's it.
No tools needed! Hope it last another 20 years

Parts Used:

Door Shelf End Cap - Left or Right Side

Katherine from Lafayette, LA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 3 people found this instruction helpful.

Was this instruction helpful to you?

light bilb went out

replaced it

Parts Used:

Light Bulb

Denise from Landover, MD
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

2 of 6 people found this instruction helpful.

Was this instruction helpful to you?

frezzer iceing over and not cooling the refrigerator

Just removed the two screws and unpluged it.
Then I pluged the new one in and replaced the screws. It runs like a brand new reffrigerator.
Thanks for the fast delevery. Will do busness with you in the future.

Parts Used:

Defrost Timer - 60Hz 120V

Marcus from Pine Hill, AL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 4 people found this instruction helpful.

Was this instruction helpful to you?

door end cap broken,

Put the new ordered door end caps in place, everything worked fine.

Parts Used:

Door Shelf End Cap - Left or Right Side

Edward from Piscataway, NJ
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

The door end caps were broken and not fixable

I simply placed the retention bar between the new end caps and popped it into place. Took about 10 seconds to complete.

Parts Used:

Door Shelf End Cap - Left or Right Side

Ryan from Coralville, IA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Freezer door shelf end cap broke

The only problem I had was that the end cap was sent before the rack. This refrigerator is in our cottage and I brought up the end cap while waiting to receive the rack. I couldn't remember where I put the end cap, so when the rack came it took me a few weekends to find the end cap. Once I did, it took me less than 1 minute to repair. I put the rack on the end caps & pushed the end cap in place. DONE!

Parts Used:

Door Shelf Retainer Bar - Cut to Fit

Door Shelf End Cap - Left or Right Side

Melanie from Green Bay, WY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

End caps broken

End caps snapped out of door,
Replaced with new caps

Parts Used:

Door Shelf End Cap - Left or Right Side

Russell from Clevelamd, TN
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Freezer built ice, fridge not cold enough and running constantly.

Removed front low grill, removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the wires. Reversed process to install new timer.

Parts Used:

Defrost Timer - 60Hz 120V

LUIS from CENTENNIAL, CO
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

1 of 4 people found this instruction helpful.

Was this instruction helpful to you?

sheft ends brolen

Cleaned and removed old ends, applied new ends and installed. Ends fit to order, shipping quick and parts affordable. Thank you

Parts Used:

Door Shelf End Cap - Left or Right Side

Helen from Gulf Breeze, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Wrong size listed on website.

The end cap is easy to remove and replace. The personnel at PartSelect was extremely helpful in re-ordering the correct part.

Parts Used:

Door Shelf End Cap - Left or Right Side

Elizabeth from Weems, VA
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

loud noise fan blade broke,off balance

take 1/4 hex screws out clean out dust ,remove old fan blade replace with new install bolts .

Parts Used:

Evaporator Fan Blade

EDWIN from ELWOOD, IN
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

freezer worked frig was warm. Ice maker is still not working

Removed two screws to get to defrost time pull panel down remove two screws holding time and reinstall

Parts Used:

Defrost Timer - 60Hz 120V

steve from Kirkland, WA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Screw drivers

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

clips on both end caps we broken and the crossbar kept falling off.

First i pulled the crossbar off the door, then I pulled both end caps off the crossbar and then I
put the two new end cap on the crossbar and then tapped snoggly into place with the palm of my hand. Job done. took all of about 5 seconds.

Parts Used:

Door Shelf End Cap - Left or Right Side

Frank from Orange Park, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 1 people found this instruction helpful.

Was this instruction helpful to you?

Freezer okay, but fridge was warm

Website was great!

The defrost timer was right in front. 2 minutes and a screwdriver and I had it replaced.

To replace the thermostat, I had to take out the back panel, defrost it and then install the new part. the only problem was that the heatshrink tubing they sent was too large. Otherwise, it worked great.

Parts Used: