All Installation Instructions for 1808

The light went out

I pried the old one out with a screw driver and pushed the new one in. I expected instructions in the box it came in but there were none.

Parts Used:

Refrigerator Door Switch

Janet from Flagstaff, AZ
Difficulty Level:
Easy
Total Repair Time:
Less than 15 mins
Tools:
Screw drivers

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

light switch would not work

Popped the old one out with a kitchen knife and popped the new one back in. It tool less than 15 seconds!!

Parts Used:

Refrigerator Door Switch

Joseph from Destin, FL
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 2 people found this instruction helpful.

Was this instruction helpful to you?

Pump seal elak

Removed motor and found shaft severely rusted. Cleaned up the rust but the shaft was too pitted to work effectively with the new seal.Wasted my time and money

Parts Used:

SEAL-PUMP

Richard from Northville, MI
Difficulty Level:
A Bit Difficult
Total Repair Time:
1- 2 hours
Tools:
Nutdriver, Pliers, Screw drivers

1 of 5 people found this instruction helpful.

Was this instruction helpful to you?

Bottom shelf support between crisper drawers broke

It was simple to just replace the shelf support. This is the thrid time I have used Parts Select for replacment parts. They always have the parts in stock, ship really quickly and it's a beeze to search their site for the parts I needed every time. Parts Select is now at the top of my Favorites list when it comes to appliance repair needs. Thanks to everyone at Parts Select!

Parts Used:

Crisper Shelf Support Kit

Lauretta from Bethpage, NY
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

1 of 7 people found this instruction helpful.

Was this instruction helpful to you?

Switch was not working after a repairman had fixed something else

Please bear in mind I am 65 years old & it was harder to get up & down off the floor then to change the switch. Was very easy - watched video, unplugged unit. I used the putty knife at the right front corner to work loose, when it came loose had to loose the left side a little. The unit pulled out easily. detached the wired that had a single plug with 2 prongs on it. Attached the plug, pushed new switch into place. There was no way you could place wires on wrong prong. When done, plugged refrigerator back in & checked if working. I CAN SEE THE LIGHT and the food in the freezer now. Thank you for making an easy repair.

Parts Used:

Refrigerator Door Switch

Jackie from Nova, OH
Difficulty Level:
Really Easy
Total Repair Time:
Less than 15 mins

0 of 4 people found this instruction helpful.

Was this instruction helpful to you?

noisey fan

yup

Parts Used:

Refrigerator Condenser Fan Motor Kit

Richard from Morgan, UT
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers

0 of 4 people found this instruction helpful.

Was this instruction helpful to you?

Condensor motor was frozen

pull unit away from the wall, and unplug it. remove the grill, and cardboard guard on the lower back of the unit. remove Three screws for the motor bracket. Remove the bracket legs from the old motor and assemble them to the new motor. take the fan blade off the old motor, place it on the new. Cut the wires at the old motor, strip the insulation back, use supplied wire nuts to connect the new motor. Reverse order to reassemble. Plug in unit to test function.

Parts Used:

Refrigerator Condenser Fan Motor Kit

john from thibodaux, LA
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers

Was this instruction helpful to you?

excessive water in condensate pan

just as video instructions said, very easy just following them ,part arrived in very short time and was exact fit completely satisfied, saved repair man service charges and wait time

Parts Used:

Refrigerator Condenser Fan Motor Kit

michael from woodstock, MD
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Socket set

Was this instruction helpful to you?

Leaking motor seal

Followed easy instructions and completed repair in less than 30 minutes.

Parts Used:

Impeller and Seal Kit

Robert from Willcox, AZ
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

Condensor Fan going bad

I knew the repair wasn't difficult. It was a matter of finding the replacement part. Luckily, I found the part via the internet on your site. Lucky for me, there was an installation video!! These videos are worth 1000 bucks!! Never have encountered a site with installation videos before. It gave me complete insight as to how the job was sequenced. I'm a very visual person, so videos are the perfect helper for me. With fewer and fewer affordable local service companies around to fix problems like mine, your site gave me the complete confidence to easily switch out the condensor fan. I completed the repair for about $63.00. Your site ROCKS! Keep up the repair videos because they are awesome and extremely helpful. I felt like your pricing was competitive for this item. Thanks again!!

Parts Used:

Refrigerator Condenser Fan Motor Kit

George from Hickory, NC
Difficulty Level:
Really Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers

Was this instruction helpful to you?

multiple rust spots on the old rack

Original part no longer made. Substitute too small by a half an inch. Corrected the problem by removing the 4 corner wheels from the old rack and put them on the new one. Now, it fits and works perfectly.

Parts Used:

Silverware Basket (Grey)

Clifford from Saint Louis,, MO
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Pliers, Screw drivers

Was this instruction helpful to you?

condenser motor broke

opened box,read directions,took out bad motor,installed new one.PRESTO CHANGO way to go.

Parts Used:

Refrigerator Condenser Fan Motor Kit

patrick from livonia, MI
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Pliers, Screw drivers

Was this instruction helpful to you?

Condensor fan motor quit working

Pulled the fridge out, Took bottom panel off. Removed 3 screws holding motor. Unplugged connector, cut wires, attached old connector on new motor. put blade on new motor.installed in fridge, put cover back on.

Parts Used:

Refrigerator Condenser Fan Motor Kit

David from New Albany, IN
Difficulty Level:
Easy
Total Repair Time:
15 - 30 mins
Tools:
Nutdriver, Screw drivers

Was this instruction helpful to you?

Refrigerator was running very cold

Unscrewed the right control knob. Removed the left temperature control knob (there is no screw holding it), removed one screw to rear of small panel then pried open from the rear of the small panel, there are two plastic tabs in front of the small panel holding it in place. Unscrewed the failed control unit and replaced it with the new one. Replaced the small panel and screw then the left side control knob, making sure of the alignment in the "off" position as the knob has to be pressured into a clamp arrangement on the cold control thermostat. Re-screwed the right knob into place, as well.

Parts Used: