Models > 108RB545-G > Instructions

108RB545-G General Electric Range - Instructions

All Instructions for the 108RB545-G
46 - 48 of 48
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Bad Burner
There was no burner listed like 40 yr old burner that failed. Got one the same size and connections. Cut old burner out of the stainless steel ring and new burner fit right in. New burner works great
Parts Used:
Tilt Lock Hinge Mounted Surface Burner Kit - 6"
  • Grady` from Titus, AL
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    1- 2 hours
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The instructions on striping the wires was slightly confusing.
I stripped one wire on the first burner. Then I realized that the terminals were the ones that could be left. Finding a replacement terminal has proved to be difficult. Once I realized my mistake I could change the other three burners very easily.
Parts Used:
Tilt Lock Hinge Mounted Surface Burner Kit - 6" Tilt Lock Hinge Mounted Surface Burner Kit - 8 Inch
  • Katherine from Berkeley, CA
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
only half of burner working
Replaced the old with the new following directions (mostly).
Parts Used:
Tilt Lock Hinge Mounted Surface Burner Kit - 6"
  • KENNEDY from OCEAN GROVE, NJ
  • Difficulty Level:
    A Bit Difficult
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers, Socket set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 108RB545-G
46 - 48 of 48