Models > 107RC75A > Instructions

107RC75A Hotpoint Range - Instructions

All Instructions for the 107RC75A
31 - 32 of 32
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Replace heating element on range top
Shut power to unit. Tilted burner element back, then removed pan screw,with nut driver which holds rear hinge in place. Next step was to remove clips that hold porcelain cover that covers the wires.Used nut driver to remove the three the wires. Installed new unit in the reversed order. Just make sure wires replaced in proper order. really easy !
Parts Used:
Drip Bowl - 8 Inch Drip Bowl - 6 Inch Tilt Lock Hinge Mounted Surface Unit - 6" Tilt-Lock Hinge-Mounted Surface Burner - 8"
  • Ronald from Yonkers, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver
Was this instruction helpful to you?
Thank you for voting!
A plastic bowl was placed on the hot eye and melted.
The old eye was lifted up, hinge screw removed, and three screws removed from the eye that connected lines to it. Did just opposite for installation. Very easy. The hardest problem was finding an eye with three screw-type connections.
Parts Used:
Tilt Lock Hinge Mounted Surface Unit - 6"
  • Hubert from Oak Ridge, TN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Nutdriver, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the 107RC75A
31 - 32 of 32