10650043717 Kenmore Refrigerator - Instructions

Used screw driver to pop out old switch. Used pliers to hold wire connection from fall back into slot on fridge. Inserted new swith into plug and pressed new switch back in place.

shook bottle and painted waited a day and repeated

I installed a Ice Door Kit. It works Great Now!

new auger and drive wheel

Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discoloring refer handles. Thank you

I had several times tried to get the old switch out but with no success. Ordered the "repair kit" and followed directions for removing old switch (there is a plastic spring clip on one side). Easy to unplug the old switch, plug the leads into the new one, snap the new one into place. Took about 5 minutes total--piece of cake. I wish I'd thought to try this years ago when the old switch began to fail.

I did remove the run capacitor of the starthing kit of compressor and another one new. It work fine.

Found auger was broken. Also found the ice cubes seemed too big and not breaking apart after the ice maker would cycle and dump in to the bucket. So I adjusted the ice cubes water feed timer making the cubes smaller and they are working real good through the auger now.Thanks for delivering the part so fast.........

We used the video out on YouTube to show us how to replace the drum. It made the repair go so fast that we were amazed that two klutzes could do this repair! Remove the screws that hold the housing together. Place the screws in a cup to keep everything together. Remove the spiral unit and the plastic sleeve. The hardest part was removing the auger nut on the assembly. Just remember it is a left hand turn. After that, remember sequence of the blade assembly. The video suggested that you take a picture and that would help remembering the sequence of the blades. Follow the video!

I was unable to remove the old part so I threaded the new part in front of it. They both fit within the actuator. Done!

Unplugged appliance. Using a small putty knife I moved the switch out far enough to grab it with pliers. Moved wiring to new switch and pushed into place after testing.

Changed bulb, not the problem, had to remove switch to identify correct choice to order (3 pronged verus 2) after that it was easy beyond having to stand on my head to make the exchange. (N B before removing old switch it actually came back to life)

After years of using a flash light to check the contents of my refrigerator, I decided to try to fix the problem myself. Replacing the light switch was very easy. The directions were straight forward and I'm sorry I waited so long to tackle the problem.

Was easy, removed several screws and a clip on the auger shaft. removed broken part and replace with new then reassembled

I simply watched the repair video and did it! Super easy, needed start device and capacitor. As easy as unplugging the old and adding the new. The video helped and gave me confidence. Wives can fix fridges too! Saved me $2500. Looks like I'll need a new excuse if I want a new fridge.